What have you done to your square lately??

[brooksman9]

I could use one!

Installed a new radiator to replace the leaking like a sive one that it came with. Test drive went much better today. Still have the crank issue. May have to bite the bullet and get a new battery.

You must be registered for see images attach

 

[JamesSam]

I wish I'd have known you needed one. Got a guy out here that has a few sliding back windows.

Might hit you up in the future.

 

[WFarm]

My drivers door has always been a PITA to close all the way. I hate slamming doors or anything else for that matter, but that’s what it took to close it all the way. Then I found the thread here about using 1/2” PEX to make new sleeves for the door catch. Some of my original sleeve was still there but not much.

Bought a stick of 1/2” PEX and made and installed a new sleeve. HUGE improvement!! Door shuts normally again!

Plus I have enough left over material to make replacement sleeves for the next 1268 years.

You must be registered for see images attach

 

[JamesSam]

Installed.

You must be registered for see images attach

I sure did have to help quite a bit.

 

[JamesSam]

Installed.

You must be registered for see images attach

I sure did have to help quite a bit.

But that's ok. I told the guy he was getting paid and this truck is my midlife crisis.

 

[ChuckN]

Went to the local swap meet today, scored some Mickey Thompson valve covers for 60 bucks. I’ve always wanted a set!

You must be registered for see images attach