ChuckN
Latest activity Postings About
-
-
Got some lights -
Driveshaft? Disconnect it so you can rotate the u joint enough. 4 bolts that should come out easy and if they don’t, you should get...
-
@ChuckN I got a different tip... It's called a grease needle. They have one for sale at the parts store near you. Works good. It's...
-
ChuckN reacted to FireTruck1984's post in the thread What have you done to your square lately?? with
Like.
Looks Great ! That thing’s gonna run and drive like a new truck -
Finally got the engine/transmission set in today. It's a long process, but I'm somewhat anal about some things........... New radiator...
-
ChuckN replied to the thread Rear diff weirdness.Not to hijack here- but the front driveshaft zerk fitting on my C10 is really hard to get to, my grease gun won’t fit in there to lube...
-
If the u joints are grease-able then yes. If not then no. I’ve always found greasing u joint to be hit and miss in the success...
-
Drum brakes on rear?? May want to check them out.
-
ChuckN reacted to Grit dog's post in the thread What have you done to your square lately?? with Like.
Sounds like it’s time to find a nice 6.0/6.2 to drop in that beauty!
-
ChuckN reacted to TotalyHucked's post in the thread What have you done to your square lately?? with Like.
@ChuckN I only noticed it once we got home but it seems to be smoking at idle and during revs/while the revs come back down. I was about...
-
ChuckN replied to the thread What have you done to your square lately??.@TotalyHucked sorry to hear that. Is it smoking all the time? Just on start up? Might just be a valve seal or three sucking oil into the...
-
ChuckN reacted to TotalyHucked's post in the thread What have you done to your square lately?? with Sad.
Did C10s in the City this weekend, I had to drive our dually and trailer down there so the GF drove the hotrod Went to check the oil...
-
ChuckN reacted to 82sbshortbed's post in the thread What have you done to your square lately?? with Like.
Put my old plug wire boots over the wires to protect from hedder heat. Hooked up new battery cable after bolting starter back on. And...
-
-
ChuckN reacted to AyWoSch Motors's post in the thread What have you done to your square lately?? with Like.
Haven't been able to do too much to any of my stuff lately, between it pouring rain almost non stop, and being flooded with clients...
-
-
Loading…
-
Loading…
