Latest activity
-
C10MixMaster replied to the thread 1987 Burb TBI to carb swap.I have actually been chasing vapor lock on my truck , when the outside temp hits 95+ degrees you can watch the fuel pressure drop to... -
Joshua Keith reacted to FireTruck1984's post in the thread 81-87 Body molding measurements? with
Like.
Correct, because the measurements vary throughout the length of the truck,.. Measuring from the body line to the top (or bottom) of the... -
scrap--metal replied to the thread Correct Driveshaft Length for 700-R4/NP208/14bolt FF.There are some M1008 driveshafts currently on eBay. I'm considering buying one of those instead of the conversion U-joint. That'd... -
82sbshortbed replied to the thread Brown Tire Issue???.Mine stay black even after the tire shine wears off. It's sits outside 24/7/365. -
-
FireTruck1984 replied to the thread 81-87 Body molding measurements?.Correct, because the measurements vary throughout the length of the truck,.. Measuring from the body line to the top (or bottom) of the... -
-
OOaasport replied to the thread 1987 Burb TBI to carb swap.The block is a 1979 block, mechanical pump. Thats why i was looking into find a carb tank lines and sending unit
-
Doppleganger reacted to Rusty Nail's post in the thread What kind of tool box do you have at home?? with Like.
Hay look. Even @Don5 made the board switch. :wave: This topic reminds me of Indiana Jones? This is the box of an auto mechanic... -
SSoCaliSubrbnAsslt reacted to shiftpro's post in the thread front add-a-leafs (pic request) with Like.
Not a good idea Eric... you're putting a band aid on an infection. Your front springs are sacked, and propping them up with another...
-
Bextreme04 replied to the thread 1987 Burb TBI to carb swap.Have you ever actually seen that? I'm pulling through an EP381 and haven't had any vapor lock issues. The design of the pump shouldn't... -
Joshua Keith replied to the thread 81-87 Body molding measurements?.Thank you all! I think you guys are absolutely correct. Idk why LMC would advertise those measurements.
-
Presuming your tape line is the bottom of the trim, looks like 12" is the right number as your line looks about 1" low. Look at...
-
Joshua Keith reacted to FireTruck1984's post in the thread 81-87 Body molding measurements? with Like.
For best results and perfectly straight moldings… Don’t measure. use FineLine tape (like pinstripe tape) to run the length of the truck...
-
Eel chevy replied to the thread New here hellow.I have a pic of what I have now the other one was right next to it
-
-
-
Catbox reacted to 82sbshortbed's post in the thread What kind of tool box do you have at home?? with Like.
Holy **** batman! When did you take a picture of MY toolbox? How did you get in my garage? Lmao Dude I've gotta take a picture of it...
