-
-
The only reason for the common belief that ram horns are better is due to the 2.5” ones pictured above from a H.O. 327 Corvette. The... -
I just want to say that Ricko is continuously going above and beyond on this forum and his post is representative of this. While I might...
-
You could always just go crazy and smear a few hundred dollars worth of body filler if the seams and spot welds bother you ;)
-
AGAIN like @TotalyHucked asked.......what about the TV cable?????
-
Old Guy Bill reacted to K5 Blazer's post in the thread 1973 Tailgate Trim Band Replacement with
Like.
Needed new door hinges put on the Blazer so I took it to the bodyshop. While it was there, I had them restore my original tailgate trim... -
Old Guy Bill reacted to legopnuematic's post in the thread Think I found a somewhat rare truck with Like.
I’d say you’d be more likely to find a short bed step side 454 C10 that does have the F44 rpo (big ten/heavy half) than not, as (until...
-
-
Even if it’s parked outside in North Dakota year round, the amount of UV compared to where @SquareRoot lives is considerably less. When...
-
Old Guy Bill replied to the thread 85 vent windows.I had intended to have those pieces powder coated black when I had my wing windows all disassembled. But time constraints got in the...
-
Old Guy Bill reacted to Grit dog's post in the thread dose anyone have any good pictures of a 3inch body lift with Like.
Doesn’t matter how good the pics are. A 3” body lift will look like ass.
-
Yep. I can only remember replacing just one. It was a brown '80-ish Malibu.
-
Old Guy Bill reacted to Ricko1966's post in the thread Replacing a single frame rail, can it be done? with Like.
Well I've seen quotes on Kansas web sites about how much it curbs auto theft. And even though it can be a PITA I can see the good in it...
-
Hello, everybody! For the past 15 years I have owned a 6.2-powered 1982 C10, which the previous owner pepped up with a Banks Sidewinder...
-
I know its getting into oil somewhere, might not be big leak , but Id like to figure out where, Im gettin too old to be climbing over...
-
Old Guy Bill reacted to bucket's post in the thread Replacing a single frame rail, can it be done? with Like.
I agree, if only changing the rail, it will be straight enough. But if replacing all the rivets on the other rail too, it will need to...
-
-
Loading…
-
Loading…
