V
vr1967
Latest activity Postings About
-
-
Vvr1967 replied to the thread whats every body using.. looking for a new stereo head unit.I’ve still got a shaft, blue light Kenwood cassette radio. Thought of seeing what it would take to get usb or aux fitted to it. Dash has...
-
Vvr1967 replied to the thread My other special vehicle.Keep it like it is and enjoy it. I have people always telling me I ought to engine swap etc the 65 C10 that my grandfather bought new. I...
-
VMy other special vehicle is a 1967 Pontiac GTO and keeping it the way it is. It was handed to me 10 years ago, was my late older...
-
VMy truck is one or two notches uglier than yours.. This bumper perfectly bridged the gap between the new hitch and box. A stock bumper...
-
Vvr1967 replied to the thread What is this part?.Fuel tank shield, RPO NY1 would be my guess
-
Vvr1967 replied to the thread The infamous 10" bumper.I’ve got an old Bailey drop bumper from the 80s on my truck. They were made in Oklahoma. Old photo, but got it to go with the early, non...
-
-
VSoooo, while she looks a little rough, I just have one little bit of rust at the rear window, and body work is done. I will use 3M seam...
-
VThis is "just" a 307 with Vortec heads and a small RV cam in it and 9.3:1 compression.... It currently has 1979 Malibu iron manifolds...
-
Vvr1967 replied to the thread Dashboard "frame" removal 1984 GMC C1500.I’ve got a hacked one I plan to replace. I plan to cut from the defroster duct to speaker opening to the side and leave the forward...
-
VMy Dad was a lifelong trucker, mechanic, welder, fabricator, etc. He was building this 66 Needlenose Peterbilt 351 into a custom truck...
-
Vvr1967 replied to the thread Finally got a running 65 C10.Yes we used to bore them .125 over in the early 80s and called them 301s not realizing that made a 4 inch bore and basically a 302 like...
-
Vvr1967 replied to the thread TBI diagnosis reminder.Also, here are the flow charts from the service manual to help diagnose issues
-
-
Vvr1967 reacted to RanchWelder's post in the thread Disassemble Clean Roller Lifters, for L31 Vortec SBC with
Like.
When it's time to re-assemble each clean dry piston, spring, plunger and stainless cap, make use of a hex nut driver, so you can squeeze... -
Vvr1967 replied to the thread OEM cylinder head castings - 1977 K10.Here is a 1975 cast thick block. Can see the wide pad and cast dates in photos 7 & 8...
-
-
Vvr1967 replied to the thread OEM cylinder head castings - 1977 K10.Remember that GM went to thinner (lighter) castings in 1977, so if you get 882 castings, there is a difference in early and late heads...
-
-
-
Loading…
-
Loading…
