Oldbear42
Latest activity Postings About
-
-
Oldbear42 replied to the thread PVC and PEX for Compressed Air.A garage sale find... it is a post-hole digger that lets you better scoop out the dirt in a deeper hole. The handle moves the shovel... -
Ill sell you mine -out of the truck-for half that. Holla atcha boi! :headbang: $30 ~ pst
-
Oldbear42 replied to the thread wiring issues.Check your grounds (as others have said). As I was working on my "new" truck, I was replacing ground straps as I found them. The...
-
Oldbear42 replied to the thread PVC and PEX for Compressed Air.I used a few Maxi-air kits, as they were on sale. It gave me some drop-down junction blocks that allow an air fitting, drain valve, and...
-
-
Oldbear42 replied to the thread 2 post shop lift.I'll start this with the disclaimer that I have a 4-post. Both lifts are better than no lift. If I had room and money, I would have...
-
-
Oldbear42 reacted to Goldie Driver's post in the thread What have you done to your square lately?? with
Haha.
Did an accidental battery test as I went out this morning and noticed the dome light was on. From ... last... night ....when I fired... -
Oldbear42 reacted to Tonimus's post in the thread What have you done to your square lately?? with Haha.
I put a sticker on.
-
Oldbear42 replied to the thread What have you done to your square lately??.I finished installing my vintage auction find, an original bush guard. It required fabbing a new mount as one was poorly repaired years...
-
-
Oldbear42 replied to the thread Filling small holes without welding.I have a redneck copper spoon for welding holes in sheet metal. It's a 1" copper pipe flattened and folded, then attached to a handle...
-
-
Oldbear42 reacted to Doppleganger's post in the thread Filling small holes without welding with Sad.
A friend of mine came by about a year ago - he'd been welding 40+yrs - and couldn't stop from turning small holes into bigger ones on...
-
If you've got an oxy acetylene outfit I'd braze them shut.
-
My buddy asked me if I could weld up some 3/16 holes in the trunk of his 69 442 this weekend. I have a 120V mig welder that I use 99% of...
-
Oldbear42 reacted to Octane's post in the thread Surface rust. What are the best practices? with Like.
I knocked the loose rust off my floorpan and used ZeroRust on it.12 years later still in good shape.
-
Oldbear42 reacted to CalSgt's post in the thread Surface rust. What are the best practices? with Like.
not sure on the bed… The stuff in the cab I would knock any loose stuff off and epoxy or encapsulate. A D/A with 220 should make light...
-
-
Loading…
-
Loading…
