Suggestions for replacing this?

[Dleslie212]

I've read that these aren't made anymore. This is the sleeve for the body mount bushing on the passenger floor. All the others were in decent enough shape that I cleaned them up, painted and reused.

Anybody know where to get a replacement?

You must be registered for see images attach

You must be registered for see images attach

You must be registered for see images attach

You must be registered for see images attach

 

[Ricko1966]

Easy to make,use appropriate size hole saw cut a disc out of flat stock,cut a short piece of dom,drill the hole in your disc to fit your bolt. Weld,braze or just let it float its captured .

 

[Dleslie212]

Float its captured, meaning just let them rest together without welding them together?

 

[Grit dog]

Ya, I’ve used a couple fender washers and an appropriate size piece of tubing. Bam.

 

[Bennyt]

Looks like you are in Phoenix, I'm on the westside. I have a couple of buckets of old parts. As soon as the sun goes down a bit, I'll dump them out and see if I saved any.

 

[Dleslie212]

Looks like you are in Phoenix, I'm on the westside. I have a couple of buckets of old parts. As soon as the sun goes down a bit, I'll dump them out and see if I saved any.

That'd be badass thank you

 

[Bennyt]

That'd be badass thank you

Ok, not in my shed. I have a few other bins to dig through. I can do that Tuesday. I also am about to install poly bushings on my C30 later this week. If those are the same you are welcome to them as well.

 

[Dleslie212]

That's what I'm doing is poly bushings on my k10.

Thank you for looking - don't go overboard searching or anything, I appreciate the effort you've already spent

 

[Dleslie212]

You must be registered for see images attach

You must be registered for see images attach

You must be registered for see images attach

You must be registered for see images attach

 

[Dleslie212]

I ended up taking the old one along with one of the new poly bushings to a local metal fab shop and they whipped one up for me

 

[Dleslie212]

Who here has done the Energy Suspensions body mount bushings? Im looking at the diagram and it shows the cone shaped bushings on top, with the smaller end of the cone facing into the bushing sleeve. It just doesn't seem right. Can anyone confirm proper orientation?

You must be registered for see images attach

 

[Dleslie212]

You must be registered for see images attach

You must be registered for see images attach

 

[DoubleDingo]

Does a shop manual show it?

 

[legopnuematic]

The cone goes on the bottom, small end facing the ground.

 

[Dleslie212]

The cone goes on the bottom, small end facing the ground.

That's what I was thinking, and how i did my driver's side. Thanks for the confirmation