-
-
BGot the kick panels installed and all the wires ran for the amp. Definitely not a direct fit, and drivers side had the challenge of the...
-
BI'd just push a piece of 6 in channel iron up against the frame rails in front of the sway bar drill 3 holes per side bolt it up, it...
-
BBennyt replied to the thread Can't get rid of play in the steering.Wow, didn't know they were that flexy those years! I'll have to take a closer look at one next time I see. I was actually going to use...
-
BBennyt replied to the thread Can't get rid of play in the steering.Not worth it unless you want the wow factor. The problem with the front cross member is that they are riveted. Remove the rivets and...
-
BBennyt replied to the thread Uneven rear main seal, help needed..I doubt crank is damaged or machined wrong and most likely just a bent/ damaged rear seal housing. I assume the crank turns over...
-
BFair enough. I’ve never had those failures, but I wouldn’t be happy if I did. I’m really surprised that a name brand bag would rupture...
-
BBennyt replied to the thread V2500 4in lift replacement? ORD?.When they work, they are great. But, I can't think of anyone I've ever met/ known that has had them work perfectly/ reliably from day of...
-
BBennyt replied to the thread What would you pay for this truck?.We cut my son's truck down but not totally sure I'd buy one already done unless I knew who did the work. A lot of them have z'd frames...
-
BLike this? Also a clue to where I live if you don’t look at my location on the left where yours says Miami…. I strongly considered...
-
BBennyt reacted to zulander's post in the thread 1985 1 Ton Dumptruck 11Ft bed with fold down sides,lots of new parts,receipts for all,chassis saver. $15,000 OBO with
Like.
1985 1 Ton Dumptruck 11Ft bed with fold down sides,lots of new parts,receipts for all,chassis saver. New interior, everything under hood... -
BBennyt replied to the thread How to properly remove a cab without damage.I did the same as Michael here. I used 2 2x4's with notches to keep the cab from sliding off, spaced 4" apart. If using a HF cherry...
-
BBennyt replied to the thread V2500 4in lift replacement? ORD?.Just some thoughts based on my K5 build. 35" tire will hit the back of the front fender if going off-road. I'd go 6" lift or 33" tire...
-
BBennyt replied to the thread interior rehab.Looks good so far! Please put up how the dash fits after install and the brand/ supplier. Lots of mixed feedback on quality/ fitment of...
-
BBennyt replied to the thread Seat frame Question......Ppretty sure all 73-79 folding bench seats have that. It's on the 3-4 benches I have. I don't know about the 80+ but I can check tomorrow.
-
BIt is there to lock the seat in heavy braking so it doesn’t fly forward. If I remember correctly it uses inertia to activate the lock.
-
-
Loading…
-
Loading…
