Suggestions for replacing this?

[Dleslie212]

I've read that these aren't made anymore. This is the sleeve for the body mount bushing on the passenger floor. All the others were in decent enough shape that I cleaned them up, painted and reused.

Anybody know where to get a replacement?

You must be registered for see images attach

You must be registered for see images attach

You must be registered for see images attach

You must be registered for see images attach

 

[Ricko1966]

Easy to make,use appropriate size hole saw cut a disc out of flat stock,cut a short piece of dom,drill the hole in your disc to fit your bolt. Weld,braze or just let it float its captured .

 

[Dleslie212]

Float its captured, meaning just let them rest together without welding them together?

 

[Grit dog]

Ya, I’ve used a couple fender washers and an appropriate size piece of tubing. Bam.

 

[Bennyt]

Looks like you are in Phoenix, I'm on the westside. I have a couple of buckets of old parts. As soon as the sun goes down a bit, I'll dump them out and see if I saved any.

 

[Dleslie212]

Looks like you are in Phoenix, I'm on the westside. I have a couple of buckets of old parts. As soon as the sun goes down a bit, I'll dump them out and see if I saved any.

That'd be badass thank you

 

[Bennyt]

That'd be badass thank you

Ok, not in my shed. I have a few other bins to dig through. I can do that Tuesday. I also am about to install poly bushings on my C30 later this week. If those are the same you are welcome to them as well.

 

[Dleslie212]

That's what I'm doing is poly bushings on my k10.

Thank you for looking - don't go overboard searching or anything, I appreciate the effort you've already spent