I don't have pics of my brackets but here's my 60/40 in my 79
All I did was make a rectangle bracket from 2" square tubing, bolted to seat then to brackets took about an hour to do
So I've been looking around for a set of 3.42's for my 1983 8 lug 14 bolt semi float rear. It dawned on my that I had a 6 lug 14 bolt sf rear with 3.42's from a 1994 chevy that I had. When I went to look for it in my pile of parts I remembered that I scrapped it. I want to know if the gears...
If you a cheapa$$ (or thrifty as I like to call it) like myself you'd rather spend 300 bucks on something worth 300 bucks and not a dash pad. I came up with a way to make your own and only have about 4 hours into it. My Initial budget was $20 and I didn't even spend that much! Here's how I did...
I absolutely HATE doing anything electrical. It literally gives me a headache trying to figure it out. That's half the reason I stick with the old squares is cuz they're so easy to work on
Well after looking at the wiring schematic I found my problem. The ground wire was completely severed from the drivers side and the pass ground wire was just holding on by a few strands. Replaced them and now it's good as new. I shoulda just looked for a bad ground to start with, that always...
I replaced the bulb and now
With lights off- turn signals in both sides flash bright as well as the indicators
With parking lights on- pass side indicator comes on and is dim, pass side signal will not turn on but now the drivers side will
With headlights on- drivers headlight is dim...