E
edgephoto
Latest activity Postings About
-
-
Eedgephoto replied to the thread Help needed getting seals/o-rings for driven gear housing.Here is one A quick Google search for "TH400 Speedo housing seal" comes back with tons of places to order from including brick and...
-
EI'll add in, the Blue Streak cap and rotor have brass contacts and better plastic. We ran those on all our square body trucks and Burbs...
-
Eedgephoto replied to the thread Nylon cam gear years.I would bet with today's plastics they would last way longer then the plastics from the 60s, 70s or 80s.
-
Eedgephoto replied to the thread To Do List - Advice?.A transmission fluid and filter change is a good idea. Do not waste money on the crappy auto parts store cork or paper gaskets. They...
-
Eedgephoto replied to the thread Searching for My Dad's 1979 Chevy Suburban.I would not waste the money. Every time you make a mod it makes it harder to get parts if you have an issue on a road trip.
-
Eedgephoto replied to the thread Help needed getting seals/o-rings for driven gear housing.In the housing that goes into the transmission, there is an o-ring around the outside. Replace that and just wet it with some oil. No...
-
Eedgephoto replied to the thread Searching for My Dad's 1979 Chevy Suburban.A backfire is caused by fuel exploding at the wrong time. I doubt it is a fuel pump. As was stated above. Look at ignition. How is the...
-
Eedgephoto replied to the thread Nylon cam gear years.This was my timing set. I have owned this truck since 1988. Not sure how many miles but somewhere close to 200K
-
-
EIt wasn't a dumb idea,and most of the cars went thier whole life without a failure,the transmissions gave up,the bodies rusted away,and...
-
Eedgephoto replied to the thread NP203 leaking. Replace or fix?.For $100 I would grab it. If you need the truck to drive every day then I would rebuilt the $100 unit and swap it out. That will be...
-
Eedgephoto replied to the thread NP203 leaking. Replace or fix?.I would take it apart and reseal it. The speedo adapter has a little seal in it. The output seal is most likely leaking due to a grove...
-
Eedgephoto replied to the thread Nylon cam gear years.I just replaced the timing set on my 1987 GMC. I have owned it since 1988. It had nylon teeth on the cam gear.
-
Eedgephoto replied to the thread Newbie to the site..Welcome, look forward to seeing pics of your project.
-
Eedgephoto replied to the thread R4 Compressor Help.Four seasons says to add the oil to the compressor then stand it on end for 1-3 minutes to lubricate the front seal. I would doubt the...
-
Eedgephoto replied to the thread Have a great Snap On dealer finally.I had a composite dead blow hammer I bought in the 90s but hardly used. I grabbed it last winter and it shattered. I gave it to a friend...
-
-
Loading…
-
Loading…
