Alternative A/C Test Methods

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

Finkaire

Finkaire
Joined
Dec 28, 2021
Posts
443
Reaction score
715
Location
California
First Name
Loren
Truck Year
1984
Truck Model
Silverado c10
Engine Size
305
When you pull the gauges from a fully charged system and the schrader leaks you can install a good cap with a good seal with a little ester or A/C mineral oil and with all probability stop the leak. I was surprised as well when told of the cap being the primary seal.
 
Last edited:

bucket

Super Moderator
Staff member
Super Moderator
Joined
Aug 3, 2010
Posts
28,966
Reaction score
23,480
Location
Usually not in Ohio
First Name
Andy
Truck Year
'77, '78, '79, '84, '88
Truck Model
K5 thru K30
Engine Size
350-454
When you pull the gauges from a fully charged system and the schrader leaks you can install a good cap with a good seal with a little ester or A/C mineral oil and with all probability stop the leak. I was surprised as well when told of the cap being the primary seal.

Right, but just because someone can get lucky and make the cap seal against a leaking Schrader does not make it a primary seal. Just like a valve cap on a wheel's valve stem, the Schrader is the primary seal. The cap is only there to keep out debris. This isn't just my opinion, but fact.
 

Ricko1966

Full Access Member
Joined
Apr 11, 2017
Posts
3,945
Reaction score
5,697
Location
kansas
First Name
Rick
Truck Year
1975
Truck Model
c20
Engine Size
350
Now to make thos more difficult,when I was taught,the instructor told us always replace the caps as a backup defence against a seeping Schrader valve. Wording was something like every now and then one will leak down over the course of months and the cap would have prevented it. That would infer to me the Schrader is the primary the cap is a backup,whether intentional or not. And I have a stack of GM training certificates as thick as a phone book LOL. @Bextreme04 gets it lol.
 

Finkaire

Finkaire
Joined
Dec 28, 2021
Posts
443
Reaction score
715
Location
California
First Name
Loren
Truck Year
1984
Truck Model
Silverado c10
Engine Size
305
A/C specialist 45yrs. primary/secondary, a leak is a leak.
Had more problems with ball valves, always carried spares, shraders too.
A nice tightly fastened service cap with a good seal might save a backyard wrench.
 

Finkaire

Finkaire
Joined
Dec 28, 2021
Posts
443
Reaction score
715
Location
California
First Name
Loren
Truck Year
1984
Truck Model
Silverado c10
Engine Size
305
Also remember to test the detector, check the checker.
Most leaks don’t get better, it should eventually show up visually as an oily spot. If you can’t find it on the engine side of the firewall it might be the evaporator. Tear down to inspect, maybe a bore scope, might have access through the resistor on the evaporator housing, check the drain tube, also a good place to put the sniffer. You can also build up pressure in the system for testing by placing a piece of cardboard in front of the radiator. Good luck, I’ve known dealers that just keep throwing parts at it as mentioned.
 

Latest posts

Forum statistics

Threads
41,857
Posts
903,628
Members
33,370
Latest member
mitchell1128
Top