fast 99
Latest activity Postings About
-
-
fast 99 reacted to Ricko1966's post in the thread Project is stalled. Cannot solve brake problem with
Like.
Did you adjust the brake booster pushrod properly? Not the rod from the pedal to the master,the one in the booster that pushes on the... -
fast 99 replied to the thread Project is stalled. Cannot solve brake problem.When bench bleeding a master do not bottom out the piston. It is possible to cut one or more cups doing so. Are the caliper bleed screws...
-
fast 99 replied to the thread LMC Dash Pad Supplier.Has anyone bought an 81 up pad recently? One I purchased [a Dashes Direct part] did not fit the cluster bezel area upper left corner...
-
-
Platigage won't tell you if the bearings are standard .010 etc. It will tell you if clearances are correct. When you resize a rod or...
-
fast 99 replied to the thread 1966 Ford Galaxie 500.I could certainly be mistaken but can't remember seeing a Cleveland or Windsor based 351 in anything older than 69. Have seen small...
-
fast 99 replied to the thread 1966 Ford Galaxie 500.probably a 352? Another one of those never will happen would be a Coyote V8 conversion in a 1957 Ford Ranchwagon with a newer chassis...
-
fast 99 replied to the thread Quadrajet Spacers.My interpretation of a hard hot soak start occurs only after a relatively short period of time. In the area of 15 minutes. Every one of...
-
If it is a 3 port pump there is no check valve in the return line,they will drain back through the return line, if you have a windowed...
-
fast 99 replied to the thread AC Condenser - Should I use New Or Original..Agree, except today original rubber parts are 40-50 years old. Would be advisable to replace with barrier hose and all new o-rings...
-
fast 99 replied to the thread 1966 Ford Galaxie 500.Always liked the 66 design. Owning a 7 Liter has always been in back of my mind.
-
fast 99 replied to the thread Replacing stock clock with small tachometer in 83 C20.I installed a mechanical temp gauge through the bezel and cut out the cluster housing as needed for clearance. Hole in bezel was made...
-
What transmission is in the truck? If it is 700r4 make sure the geometry on the TV cable is correct before you even drive around the...
-
Those new tank straps can be a real pain, I had to use a ratchet strap to get mine to conform so the nuts could be started. I would try...
-
fast 99 reacted to Bloodhound1981's post in the thread Thinking about a new smaller steering wheel, comfort grip or forever sharp? with Like.
Same here, Actually mine is out of my 1978 Camaro. I bought it when I was 16 for $400 back in 1994. I junked that POS a year later, but...
-
-
Loading…
-
Loading…
