Any tricks to getting your SB doors to close easier?

[Edelbrock]

Gotta slam the doors on the K5 to get them to close. Its annoying.

I tried messing with the door seals, adjusting the striker, lubing everything, etc. No luck.

Thoughts?

 

[Ricko1966]

Gotta slam the doors on the K5 to get them to close. Its annoying.

I tried messing with the door seals, adjusting the striker, lubing everything, etc. No luck.

Thoughts?

Are your hinge bushings worn out? Is the plastic sleeve on your door strikers?

 

[WFarm]

Sorry I can’t figure out how to link to my previous post, but I just fixed my K5 Blazer door slamming problem and posted it in Post #23,043.

 

[Edelbrock]

Are your hinge bushings worn out? Is the plastic sleeve on your door strikers?

Door bushings are OK. Plastic is gone, but the stikers are greased. Does the plastic help?

 

[WFarm]

My drivers door has always been a PITA to close all the way. I hate slamming doors or anything else for that matter, but that’s what it took to close it all the way. Then I found the thread here about using 1/2” PEX to make new sleeves for the door catch. Some of my original sleeve was still there but not much.

Bought a stick of 1/2” PEX and made and installed a new sleeve. HUGE improvement!! Door shuts normally again!

Plus I have enough left over material to make replacement sleeves for the next 1268 years.

You must be registered for see images attach

 

[YakkoWarner]

Plastic helps a lot - there was a thread not too long ago showing that PEX plumbing tubing works really well as a cheap replacement for the plastic sleeve on the striker.

 

[Edelbrock]

Cool, thanks everyone for the info - I will try to fab us some plastic for the strikers. Anything else I should try?

 

[Edelbrock]

Should I just buy these?

Amazon.com

 

[Edelbrock]

Would rubber hose work? Probably needs to be plastic, no?

 

[Ricko1966]

Should I just buy these?

Amazon.com

You should buy axle seals,brake shoes and front and rear springs.

 

[WFarm]

Would rubber hose work? Probably needs to be plastic, no?

Rubber hose doesn’t work. Answering for a friend.

 

[Snoots]

Rubber hose won't work. You can buy the new strikers if you want to spend the dough. PEX is cheaper.

 

[hey mister]

PEX tubing cut to correct length...
Fixed both my doors.
Now they close with very little effort.