2 piece driveline

[Bigred3plus3]

I have a question. Are the 2 piece drivelines keyed? Like do they only clock one way into the yoke at the carrier bearing?

Sent from my SM-G970U using Tapatalk

 

[Poppy 87]

If memory serves, I think that there is a master spline.

Sent from my XT1254 using Tapatalk

 

[Bigred3plus3]

Kinda what I was thinking.

Sent from my SM-G970U using Tapatalk

 

[bucket]

Ok, I'm curious now. Why were you asking?

 

[Bigred3plus3]

I might have a phasing issue. I'm getting a driveline vibration. But need to replace carrier bearing first.

Sent from my SM-G970U using Tapatalk

 

[Turbo4whl]

I have a question. Are the 2 piece drivelines keyed? Like do they only clock one way into the yoke at the carrier bearing?

Sent from my SM-G970U using Tapatalk

Some are keyed, most are not. The slip yoke will be missing one spline, but the front drive shaft spline will not have the one wide spline, so it can be assembled wrong.

 

[Bigred3plus3]

You know I put it together about a month ago but for the life of me I can't remember. I was in a hurry to get it bolted on cause the wife was needed my help so I was kinda rushing.

Sent from my SM-G970U using Tapatalk

 

[bucket]

I might have a phasing issue. I'm getting a driveline vibration. But need to replace carrier bearing first.

Sent from my SM-G970U using Tapatalk

Even if it only goes on one way (which I believe that's true), it's possible that the shaft could be 180* out of phase if the center u-joint was changed and the shaft not put back the same.

 

[Bigred3plus3]

Even if it only goes on one way (which I believe that's true), it's possible that the shaft could be 180* out of phase if the center u-joint was changed and the shaft not put back the same.

Yeah its Definitely possible.

Sent from my SM-G970U using Tapatalk