P
Poppy 87
Latest activity Postings About
-
-
PPoppy 87 reacted to Trucksareforwork's post in the thread I need help choosing a route for restoring my frame with
Like.
I did a frame swap on an 80 last year and cleaned up the stripped down frame. Blasted it and then coated with epoxy. I did a round of... -
PPoppy 87 reacted to ChuckN's post in the thread What have you done to your square lately?? with Like.
This morning at 3am, I was awoken by the spirit of hot rodding (aka a 16 year old with a 91 civic and a fart can exhaust trying to do...
-
PPoppy 87 reacted to ChuckN's post in the thread What have you done to your square lately?? with Like.
Shorty spark plugs in, and reconfigured the plug wires to avoid burning them. As it turns out, no heat shields needed. As noted in...
-
POne of the first things I installed in my square was a vacuum gauge to tell me if a leak was occurring. Took out a lot of guessing.
-
PAs far as the lower tie downs I used a u-bolt on the corners of the bed. I put a slight bend in them to make it a little easier to use...
-
PPoppy 87 reacted to RustyPile's post in the thread 1985 K20. Need inspection to get tags. How to wire external horn button? with Like.
The horn circuit is a simple relay controlled circuit.. Three wires and a relay make up the entire circuit. It would probably be easier...
-
PSomeone fabbed this up with two 90's truck air cleaner bases. You could then run the tall lid which would give you the factory 5" air...
-
-
Loading…
-
Loading…
Latest posts
-
-
-
-
How can i separate my rotor from hub? Looks like its all one piece need help!
- Latest: Quinn_Hanifan
-
