Need a breather for my 1987 7.4L "N", ideas?

[edgephoto]

I am restoring my 1987 V3500 with 7.4L TBI engine. The breather pipe disintegrated into a pile of plastic. GM discontinued part #14103133. I am keeping this truck stock so I don't want so goofy looking Mr. Gasket breather. I just need ideas to make something that looks decent and fits the grommets and the hose nipple on the Air Cleaner.

The grommet is made to fit a 1/2" tube.

The item I need to replace is #1

You must be registered for see images attach

 

[Edelbrock]

If all else fails:

 

[Ricko1966]

I am restoring my 1987 V3500 with 7.4L TBI engine. The breather pipe disintegrated into a pile of plastic. GM discontinued part #14103133. I am keeping this truck stock so I don't want so goofy looking Mr. Gasket breather. I just need ideas to make something that looks decent and fits the grommets and the hose nipple on the Air Cleaner.

The grommet is made to fit a 1/2" tube.

The item I need to replace is #1

You must be registered for see images attach

I'd bend something out of steel tubing,just like a brake line a fuel line or transmission line. If I didn't think I could do it in steel I'd do it in soft copper,or pex I'd paint it black when done. Push comes to shove you could use a piece of pcv hose the correct length put a spring inside it to keep it from collapsing.. it won't have a nice 90 and 45 but you could make a sweeping C shape you'd still need something,maybe a copper elbow,plastic elbow at the valve cover

 

[hey mister]

I would go to a local pull-a-part and stroll the grounds.
I woyld be looking for a close match in the "correct bends" category.
You might have to trim ends to fit.
It should not be that tough to find a tube with the 2 bends you need.
You might even luck out and find an exact match.

 

[edgephoto]

There are no yards where you can pull parts off anymore. Not near me. They are all dismantlers. The strip them and get rid of the carcass.

I probably will do what was suggested. Bend something out of steel. Just was wondering what others have done in this situation.

 

[hey mister]

There are no yards where you can pull parts off anymore. Not near me. They are all dismantlers. The strip them and get rid of the carcass.

I probably will do what was suggested. Bend something out of steel. Just was wondering what others have done in this situation.

Bummer...
I have 3 pullapart yards within 45 minutes of me.