M122 blown 5.3 in my 99 silveraydo

[Vbb199]

That's a tough one. Perhaps a long wheelbase van?

Are you looking for exact length, or one you can shorten?

one i can shorten. i was taking stuff off this weird hodge podge 99-01 extendo cab with a 4.3 and 2 pc driveshaft. i measured the shaft and it was like 78 or 82 i dont remember; approx 6" ish longer as expected when you swap a 80e in.

i WISH i wouldve just taken the 2 piece with me.

 

[bucket]

one i can shorten. i was taking stuff off this weird hodge podge 99-01 extendo cab with a 4.3 and 2 pc driveshaft. i measured the shaft and it was like 78 or 82 i dont remember; approx 6" ish longer as expected when you swap a 80e in.

i WISH i wouldve just taken the 2 piece with me.

I'm no expert on it, but generally speaking, a steel shaft in the low 70-ish range is about max you can safely go.

 

[Vbb199]

70mph?
Or 70 inch?

Ive had a steel shaft 135mph

 

[Vbb199]

So to fit the tahoe fans and rad i had to move my intercooler stuff over so it got alot tighter in there but I got it all worked out.

You must be registered for see images attach

You must be registered for see images attach

You must be registered for see images attach

You must be registered for see images attach

Tomorrow I will hook up the battery and do an electronics test... I think im ready

Still need a belt (have one for s/c but not for accessories) and to put on my shift cable. But I can check stuff out tomorrow