Liltroy
Junior Member
- Joined
- Nov 14, 2012
- Posts
- 9
- Reaction score
- 4
- Location
- Knoxville, Tn
- First Name
- Robert
- Truck Year
- 1974
- Truck Model
- c10
- Engine Size
- 305
hey guys I need some help/ opinions please. I have a 74 stepside and just dropped the transmission(th400) to replace the front seal. when I was unbolting the crossmember it seems that the passenger side uses the factory bolt holes but the drivers side is about an inch back and has had new holes drilled. The tail of the trans seems to be centered between the frame rails so the only way I can see that this would be possible is if the frame was slightly tweaked on one side??? If I try to slide the crossmmber forward an inch on the drivers side to match the factory holes then the trans mount doesnt quit line up with the holes in the crossmember. Where can I take measurements to figure out if one side of my frame is pushed back(possible from a front end hit on one side) or if the frame is warped somehow? Any help would be appreciated.