DanMcG
Latest activity Postings About
-
-
DanMcG replied to the thread Nickel Plating.I dabbled with the Caswell Plating brush plating kits, but never tank plating. they do offer a good instruction manual and materials. -
DanMcG replied to the thread 1980 K10 Stepside Frame / Help.Cool, Where did ya find the stepside bed?
-
Update: I purchased a frame from Dennis (person DanMcG hooked me up with). Also found a bed with rear fenders and steps from a late 70s...
-
DanMcG replied to the thread What is the sticker in the glove compartment?.give these guys a call, they might have a copy in stock to work with. http://www.ecsvin.com/ They do awesome work.
-
What was the "angle adjustment" that you tried? Do to how the hinge moves and all the geometry changes during it's full travel, the...
-
DanMcG replied to the thread 1980 K10 Stepside Frame / Help.Let me know if I can be of any help.
-
Dan this is exactly what I'm looking for!! I just sent him a message!
-
Good Afternoon! I have a 1980 K10 step side with a rotted frame up front by steering gear box and of course in the rear. My father...
-
I mentioned in my introduction post that my new-to-me ‘77 fired up with a few pumps after an untold number of months in the tree row...
-
DanMcG replied to the thread 1980 K10 Stepside Frame / Help.Check with this guy, I've dealt with him before without issues. https://www.facebook.com/marketplace/item/449968193437875/ he's near...
-
Try www.car-part.com. There's a frame in MA but there may be others closer to you.
-
Scratch that float and needle question. I found some diagrams that helped me to understand. I will take the carb off next week and...
-
-
Loading…
-
Loading…
