DanMcG
Full Access Member
- Joined
- Jun 28, 2014
- Posts
- 1,076
- Reaction score
- 1,893
- Location
- Central NY
- First Name
- Dan
- Truck Year
- 1978 1985
- Truck Model
- k10 k10
- Engine Size
- 400 350
I just installed a 4" lift steering arm (Rough Country) on my k10 but the cone washers don't seat as deep as the originals did. Originally they sat about 1/16" high now they're a good 3/16" above the arm. I thought maybe torquing the nuts down would sink them deeper into the arm but that didn't happen.
Could it be the cone in the arm wasn't machined deep enough? Is this unusual? or should I pull it apart and start over?
Thanks
Could it be the cone in the arm wasn't machined deep enough? Is this unusual? or should I pull it apart and start over?
Thanks
