A pillar repair
- Thread starter 4RCustom
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
Rickf
Full Access Member
- Joined
- Jul 29, 2017
- Posts
- 468
- Reaction score
- 561
- Location
- Grafton NH
- First Name
- Rick
- Truck Year
- 1974, 1954 & a 1937
- Truck Model
- K20
- Engine Size
- 350
I ended up taking a sawzall to a doner vehicle.
Grit dog
Full Access Member
- Joined
- May 18, 2020
- Posts
- 6,008
- Reaction score
- 10,006
- Location
- Washington
- First Name
- Todd
- Truck Year
- 1986
- Truck Model
- K20
- Engine Size
- 454
^Same here.
Was going to drill out all the spot welds and replace entire skin but ended up being able to cheat and just cut out what was bad and left the pinch welds alone, since the rot wasn’t as bad as I initially thought.
Bigger areas I cut to fit patch pieces out of the donor parts. Small spots I just welded up and any small rust holes along the bottom edge of the windshield frame, I turned into additional drain holes into the cowl area similar to the 2 factory holes.
Was going to drill out all the spot welds and replace entire skin but ended up being able to cheat and just cut out what was bad and left the pinch welds alone, since the rot wasn’t as bad as I initially thought.
Bigger areas I cut to fit patch pieces out of the donor parts. Small spots I just welded up and any small rust holes along the bottom edge of the windshield frame, I turned into additional drain holes into the cowl area similar to the 2 factory holes.
Similar threads
