Rickf
Latest activity Postings About
-
-
Rickf reacted to ChuckN's post in the thread Fuel gauge to tachometer, clock to fuel gauge with
Like.
Hey Alex, when I did that conversion I used the LMC tach kit. I could be wrong, and I don’t know if Summit includes any provisions for... -
Been a while since I did an update. Even though I bought the 2wd to 4wd conversion kit, we decided to do a frame swap instead. The 2wd...
-
Rickf reacted to Ricko1966's post in the thread Instrument cluster swap from Idiot lights to full gauges K5 K10 K20 K30 C10 C20 C30 with Like.
Something to take note of,your senders need to match the year of the gauge cluster you pick,not the year of your vehicle.
-
Rickf replied to the thread Gas to diesel.Depending on your skill level you can do it, however it's probably quicker and cheaper to buy a diesel truck.
-
Rickf reacted to TotalyHucked's post in the thread Trans braces not installed when motor went in, can I fix with a little welding/fab work? with Like.
I would lift/jack the motor up and install the way they were intended
-
Rickf reacted to bucket's post in the thread Need help identifying 12v wire for electric choke with Like.
What carb are you using? The choke power wire can be the one that went to the original choke coil. If that wiring is gone or in bad...
-
Rickf replied to the thread Engine & transmission removal & reinstall general tips.The radiator & core support can stay in place IF your lifting device can pick it up high enough to clear. It's a little more work but I...
-
I'd rebuild the 400 and add a Gear Vendor.
-
Rickf reacted to PrairieDrifter's post in the thread after doin front end clutch and steering column,truck feels like its in 4wd with Like.
Any brakes staying on is usually a bad rubber hose. I have had a caliper seize before once my pads got too wore out it stuck the caliper...
-
Everyone has their own way but I get all 6 from the bottom and support the engine so the distributor doesn't hit I do pop the cap off...
-
I would also recommend a tank type coolant heater. Heat the engine and the cab heater too. This is one of many Zerostart brand...
-
Rickf reacted to Ricko1966's post in the thread Torque Converter and Transmission Assembly Question - Help Needed with Like.
Note to self.Read,comprehend,reread then post. Not skim,post, reread understand then delete post. My bad.
-
Rickf reacted to Radiohead's post in the thread Big block running hot. Can’t figure out the issue with Like.
If you run out of ideas, verify the accuracy of your instrumentation. To eliminate another outlier.
-
Rickf replied to the thread 1982 250cu fuel issue.What came first, the new carb, fuel pump and filter or the stumbling? Have you tried to crank it over with the fuel line disconnected...
-
Rickf reacted to DoubleDingo's post in the thread Anyone else have this "Turbo Diesel" plaque? with Like.
Faux cool
-
-
Loading…
-
Loading…
