84 K20 is getting new intake, carb and distributor

[Jake_S]

This weekend my painfully bone stock K20 (former farm truck) is getting some upgrades. I'll install the Performer intake, Holley carb and Accell distributor that I removed from my 85 Burban before I sold it. While I'm removing factory equipment the (what appears to be) the original heater hoses and radiator hoses will be replaced as well.
This will be the first of many engine mods for the truck. Headers will go on when time/money allow and remove the network of AIR tubes under the hood. Luckily the truck already has true duals with no cats, so exhuast work will be minimal.
I'll post pics of the before, during and after.

Jake

 

[Jake_S]

As promised, here are the pics

Stock setup

You must be registered for see images attach

You must be registered for see images attach

You must be registered for see images attach

Intake and valve covers off. Cleaned a crap load of carbon that was in the valley.

You must be registered for see images attach

You must be registered for see images attach

Performer intake and Accell distributor installed

You must be registered for see images attach

Holley 600 carb, Air cleaner, JEG'S 8mm wires and new hoses

You must be registered for see images attach

You must be registered for see images attach

You must be registered for see images attach

Jake

 

[Jims86]

you would be better off with the stock air cleaner.

 

[Jake_S]

you would be better off with the stock air cleaner.

How so?

Jake