-
-
A few things: So you currently don't have a rocker panel installed? If there is also not a full inner rocker or floor pan, your A and B... -
Also, just be aware you're only going to get the A-pillar gap so good. They were junk from the factory and varied WILDLY. Here's my blue...
-
iflyfisher replied to the thread Door Hinge Shims.Correct. But the original door had washer spacers and huge gaps. My dad had even added a bunch of washer beneath the striker due to the...
-
iflyfisher reacted to Russtypickle's post in the thread A Tape Trick for Adjusting Doors and Fenders with
Like.
Hi All, I thought I'd put this up as I've been working on my front clip this past week. Doing things yourself can be a pain and every... -
iflyfisher replied to the thread Door Hinge Shims.Thanks @legopnuematic and @bucket. I don’t need a final fix now. I am trying to get the door height close as I am replacing rockers. I...
-
-
There shouldn't be shims there, but it's a quick way of adjusting the door with the fender still mounted. As for causing stress cracks...
-
They are a bit tricky to get to. Deep socket and a 3" extension should do it though. Drivers side. To left is the dash, above the vent...
-
iflyfisher replied to the thread Door Hinge Shims.Thanks Zach for the feedback. Something must have impacted the cab in the past, though I really haven't found any damage. I have the...
-
iflyfisher replied to the thread Door Hinge Shims.Thanks for the replies Gents. Attached are some pix for reference. You can’t see the gap at the bottom due to the camera angle, and I...
-
-
I picked up some donor doors for my 73 K20. I noticed in taking off the driver door the upper hinges had a single washer shim while the...
-
iflyfisher replied to the thread 83 resurrection.Sweet. You have some fun hours ahead if you! Welcome aboard!
-
Newbie that has a soft spot for squarebodies. Collecting parts to make a dependable, stock appearing 83’ 2500. Friend purchased it new...
-
-
Loading…
-
Loading…
