1982 c10 Driveshaft

[82chevy350]

Ok guys I found out m driveshaft is bent hopefully that is the reason im breaking bellhousings. Anyone know the length for a 82 c10 longbed with th350 with long tailhousing with a 10 bolt rear?

 

[bucket]

Why not measure the one you have already? If it's bent, I'd think it would cause a vibration rather than breaking bellhousings.

How are your engine/trans mounts? Checked the frame for excessive flex from broken rivets, loose bolts, or cracks in the rails?

 

[RetroC10Sport]

Saw your post on FB Joey and meant to post there.

It SHOULD be 69 33/64".

 

[82chevy350]

Just was seeing if someone had it off hand! And I've got prothane motor mountd I've tried stock rubber and poly trans mount. I had a broken leak the main leaf actually I thought that was the problem but when I went to the strip it broke. I know my frame is tweaked some about where the frame steps up for the bed but don't see how it would cause it

 

[82chevy350]

Thanks retro!

 

[82chevy350]

And everything is tight no loose rivets I broke 3 bellhousings and finally just ordered a ultra bell.

 

[bucket]

What kind of times do you run?

 

[82chevy350]

Bad a 16.75 1/4 mile didn't get to tune or nothin got one run :/ its a all stock motor just wanted to run and race "legally" lol