-
-
Camar068 reacted to Spider's post in the thread What have you done to your square lately?? with
Like.
Went and played a little bit in the snow. Camped out in the burb for the first time. Luxury. Also had dual exhaust installed. Sounds good. -
Camar068 replied to the thread Can't get rid of play in the steering.gotcha....threw me off with the 3 bolt part.
-
Passenger side to drivers side,just like a receiver hitch.
-
Camar068 replied to the thread Can't get rid of play in the steering.you mean parallel/against the frame or one piece from drivers side to passenger side frame?
-
I'd just push a piece of 6 in channel iron up against the frame rails in front of the sway bar drill 3 holes per side bolt it up, it...
-
Camar068 replied to the thread Can't get rid of play in the steering.They don't have one for 4x4 yet. I got the email this morning from them, they said they are working on it.
-
Camar068 replied to the thread What have you done to your square lately??.Don't think I shared the new washer fluid jug. Need to reconfigure the mount, but it's in there and functional. Went thru 3 plastic...
-
-
Camar068 replied to the thread What have you done to your square lately??.ordered a replacement belt for my LS swap as it was cracking (2006 LM7). Anyway the belt called for 96". What I used was 93" when I...
-
Camar068 replied to the thread What have you done to your square lately??.What location did you put the gauge?
-
Camar068 reacted to ChuckN's post in the thread What have you done to your square lately?? with Like.
@JamesSam it’s a start! I hear you on the pollen, it’s going nuts here too. Got some projects in the mail from Summit. Vacuum gauge...
-
Camar068 replied to the thread Can't get rid of play in the steering.wow, thanks dude. Sent them an email and will go from there. At that price if I have to grind one rivet and it's better, why not.
-
Camar068 reacted to TotalyHucked's post in the thread Can't get rid of play in the steering with Like.
TinWorks does, I plan to add it to my truck along with the suspension goodies...
-
Camar068 replied to the thread Can't get rid of play in the steering.Does anyone offer a beefier crossmember.....where the prop valve is? I'm not seeing it anywhere. I'm in if there is one. Hell I'd...
-
Camar068 replied to the thread 4l60E ls swap k10 slips when turning.and to add, all 3 swaps had the proper gap between flexplate and TC. Learned that lesson before when it had a 350/700r4....don't tell...
-
Camar068 replied to the thread 4l60E ls swap k10 slips when turning.I'll check all mounts, but it's done it threw 3 engine swaps. I am working through some "popping" on the front end, but thats only...
-
-
Loading…
-
Loading…
