1979 C10 Information

[Mark Jones]

I need to know the following, thanks for your help!

1. I have the factory single gas tank that fills from the passenger side.......what size is fuel pick up inner diameter in the tank?

2. I have a tilt steering column......what is the procedure for tightening the column up?


3. I will install headers and I want the pipe after the headers to go strait back to the mufflers......what transmission cross member do I need to buy that will not get into my piping?


I appreciate the information. Mark

 

[Charlie]

 

[78C10BigTen]

I need to know the following, thanks for your help!

1. I have the factory single gas tank that fills from the passenger side.......what size is fuel pick up inner diameter in the tank?

2. I have a tilt steering column......what is the procedure for tightening the column up?


3. I will install headers and I want the pipe after the headers to go strait back to the mufflers......what transmission cross member do I need to buy that will not get into my piping?


I appreciate the information. Mark

Ive done the tilt tightening, its a bitch. You need the wheel puller and horn plate pusher tool. I found a vid on youtube for help. Its 3 bolts, i believe theyre 10mm