I have a 350 engine and trying to adjust rocker arms , because of tapping noise and one of them is literally pouring oil no matter how you adjust it, I changed push rod with another and got some result running comp cam 1.6 rockers
I rewired truck and installed led bulbs in turn signal but the blinker will not blink, I installed led flasher also, swapped the hazard flasher to check flasher still the same problem, hazards work fine, turn signal will not flash with key turned on and the amber will light up but not blink...
Has anyone had problems with led bulbs on their exterior lighting as far as maybe melting the lense, just trying to decide which way to go, park, brake, and reverse
I have a 83 C10 with auto. trans with headers, trying to figure the best place to locate muffler on dual exhaust, no crossmember to worry about, the mufflers I took off was positioned 5 feet from end of the headers but it waa designed to go over axle and Im exiting in from of tires, also from...
I have a 83 and trying to rewire interior lights, I ve looke drawing and found the wires 156 white, 40 orange, and 159 tan but cannot which does wahat, the side door jam has the white 156 and tan 159 cut offand thers a 40 orange leaving the under dash courtesy light cut offf and 156 seems to run...
On my Accel dist. button stopped spinning, thought I had sheared the gear, but pulled out and found the shaft was spinning but not the head, anyone ever run into this before, practically brand new, seems to be spinning on advance plate
I have a 700r4 that was rebuilt and only driven a few miles before I purchased it, I never seen it drive though, it set a couple of years without fluid, I then installed fluid and new filter but when truck started it will not shift in any gears, it has a 3600 stall, not fimiliar with stalls, but...
What would be a good set of roller rocker arms for a 350 with approx 425 hp, Ive looked at Comp Cam high energy and the Summit Racing brand rockers, I dont wont break the bank but I would like to have something that will work
I have been trying to start my truck with Chevy 350 with a Accel HEI dist but Im not getting fire to plugs, I checked power to dist at little over 12 ams, but when trying to crank it drops to between 8 and 9 volts, is this enough to still fire off,
I'm about to try to startup my 83 C10 after a complete rewire of truck, added electric fuel pump and electric fan, any suggestios before I install battery and try cranking
I talked to a muffler shop today getting quotes on installing dual exhaust and he informed me that you cant run duals on driver side by gas tank, you have to crossover then switch back over, first I'll heard of this
Im rewiring my 1983 c10 intermitt. wiper motor and have a few questions, Ive located all the wires pink 94, ppl 92, blk 150, blk/blu 97, and the gray 91, the only thing that Im not sure of is white 93, would this be the power to run motor and washer
Im rewiring 1983 C10 truck and kit calls to wire to battery power , one to ignition accy. one to nuetral safety switch, problem they dont tell you which is which, and there are 9 different blade terminals on steering column