Search results

  1. 8

    my 88 k1500, tons of pics

    That's how it should always sit IMO
  2. 8

    Well,The Blazer is not running again.

    Yep. Replaced CTS a long time ago
  3. 8

    Well,The Blazer is not running again.

    got it going with a distributor and a rotor
  4. 8

    Well,The Blazer is not running again.

    ok it needs a distributer,we got it figured out
  5. 8

    Well,The Blazer is not running again.

    it must have good fuel pressure since it's getting so much fuel
  6. 8

    Well,The Blazer is not running again.

    ha. my friend's dad owns a car shop and he's going to test the vaccum on the map sensor. Earlier it actually started..running like shit backfiring and running really rough it idled and ran..so idk
  7. 8

    Well,The Blazer is not running again.

    Not sure. I will hopefully have the money for a carburator an intake this week fuck you throttle body!
  8. 8

    Well,The Blazer is not running again.

    I posted before about a problem i had with the Blazer not running,or running right and i thought we solved the problem by blocking off the EGR. It ran fine for about a week until it would start idleing up really bad and eventually cut out and die. I could let it cool off for about an hour and it...
  9. 8

    Well The Blazer Broke Down..

    I have no emissions testing where i'm at. So fvck it
  10. 8

    Well The Blazer Broke Down..

    egr is completely blocked off,and my check engine light went off,and the blazer is running amazing
  11. 8

    Well The Blazer Broke Down..

    I'd rather just completely get rid of that damn egr
  12. 8

    Well The Blazer Broke Down..

    well after replacing all those sensors (including temp sensor) it was just the egr valve. It was stuck. After a little tapping and finessing,and some wd40,we put it back on and it ran better than it ever has! Unfortunately when i took it down the road it stuck again and i had to tap on it to...
  13. 8

    Well The Blazer Broke Down..

    Hmm.. it looks like it is getting wayy too much fuel. So we unplugged an injector and it runs better. Not good,but it does clear out a little
  14. 8

    Well The Blazer Broke Down..

    replaced iac,didnt help exchanged it for map sensor,didnt help. There is a vaccum line (I think manifold vaccum or somethine,saw it on a diagram) that is unplugged. for the life of me i cant find out where it goes, it's not long and when i put my finger on it to block it off it made no...
  15. 8

    Well The Blazer Broke Down..

    That's the problem,I can rev it and it runs normally,but at an idle it refuses to run. Yea it could be the filter too,but the pump is turning on when i turn the key on
  16. 8

    Well The Blazer Broke Down..

    Well it used to surge when the motor was cold and then it would occasionally surge while low rpm driving,now it refuses to start,but if i try for a while it will start and barley or not run at low RPM. Could it be idle air control valve?
  17. 8

    Well The Blazer Broke Down..

    I already replaced the ignition module before when i was at a freind's house and i turned it off and when i was leaving it wouldn't start back up. Turned out to be ignition module and it ran fine,other the the occasional surge
  18. 8

    Well The Blazer Broke Down..

    I was going to a trail tonight,and just before i got on the highway the truck starts cutting out then dies. So I try starting it and it runs for about 2 seconds and dies and would not start again. So I get it pushed into a gas station,and get my friend with a jeep to pull me home. So I try...
  19. 8

    New here from MS K5 Blazer

    Thanks man
  20. 8

    New here from MS K5 Blazer

    everything you can do to it was done. I'm going to have to dissagree with you on that,i like 700r4 more than the th350.
  21. 8

    New here from MS K5 Blazer

    it was like 3k. I wish i could remember all the stuff that went into it. Cause there was ALOT. 3k is all put together and ready to go in
  22. 8

    New here from MS K5 Blazer

    Thanks man. Who did you did you build your 700r4? lol do you mean who built it? A transmission shop here in town. It's working great. Everything that could be done to it,was done.
  23. 8

    New here from MS K5 Blazer

    Thanks guys! Build thread in my sig. Lots of pics,and im still working on it and adding pics
  24. 8

    New here from MS K5 Blazer

    Many thanks

Latest posts

Forum statistics

Threads
42,303
Posts
913,355
Members
33,800
Latest member
504SquareBody
Top