Search results
-
B
Block question
Thanks guys! Gonna put in forged crank/rods/pistons soon! Looking to make 450 NA then throw a turbo on it!- Big10-1978
- Post #7
- Forum: Engine & Performance
-
B
Block question
It’s definitely a broken piece and I’m not sure what either bolts into the front or some dowel pin goes into the bottom. I haven’t seen any assembled engines that use either the treaded hole or the opening on the bottom though so I’m not sure. I’m familiar with mostly building modular ford engines.- Big10-1978
- Post #4
- Forum: Engine & Performance
-
B
Block question
Hey guys! I bought a 383 block a few years ago and I’m finally ready to start building it. Upon further inspection I noticed a broke piece in a hole that is underneath where the mechanical fuel pump goes. What is the circled pieces function (1st pic with orange block) and if there is a whole...- Big10-1978
- Thread
- Replies: 10
- Forum: Engine & Performance
-
B
Camshaft flexibility for 1978 350
I know what you are saying, and I agree. It went from a small rebuild/upgrade to a full on $6-7K build real fast. I was hoping to slowly get into this paying a little at a time. Thanks for the feedback!- Big10-1978
- Post #3
- Forum: Engine & Performance
-
B
Camshaft flexibility for 1978 350
Good Morning everybody! I am looking at getting a cam for my completely stock 350 engine in my 1978 Chevy C10 Big Ten truck. I want something that will work now, but also work with my future 383 built stroker engine with Edelbrock E-Street Cylinder Heads 5089 and Edelbrock Performer EPS...- Big10-1978
- Thread
- Replies: 4
- Forum: Engine & Performance
-
B
Inherited grandfathers truck!
New guy here.....been a mustang and jeep guy my whole life. I just inherited my grandfathers 1978 big10. It has been very well taken care of and lots of memories from my childhood. I am in shock and awe that he gave this to me. I love to modify vehicles...my wife says it's an addiction! I...- Big10-1978
- Thread
- Replies: 24
- Forum: Introduction
