Got the truck from a buddy engine was built by a local performance shop and trans was built in 2016 so I’m sure it out of warranty and I have adjusted the kick down . Before you could stomp on it and it wouldn’t kick down now I have it to where it will kick down . All vacuum lines look good it’s...
Fluid level is fine and I’ve tried adjusting the modulator and still didn’t change anything
The motor has Bowtie phase 2 heads non vortex and a air gap intake
Is there any certain way to test for a bad torque converter ? Tach might be a light off but I don’t think it’s too bad
1981 C10 with a 383 and th350
It has to warm up for at least a few minutes in 30-40 degree weather. not as bad in warmer weather but still takes some time.
It also seem to shift fast like it’s going about 25 and already in 3rd gear
And finally the trucks has 3.42s with 295/59/15s tires . At...
Bought a 86 k10 that had set for about ten years . I’ve got it running again but the clutch just goes to the floor. So I’ve got a new master and slave because both are leaking but tried moving the clutch fork and it was stuck . Took a hammer and just tapped it to free it up (probably shouldn’t...