Search results

  1. Patrick Reeve

    Th350 has to warm up before moving and more

    Ok I’ll check that
  2. Patrick Reeve

    Th350 has to warm up before moving and more

    Got the truck from a buddy engine was built by a local performance shop and trans was built in 2016 so I’m sure it out of warranty and I have adjusted the kick down . Before you could stomp on it and it wouldn’t kick down now I have it to where it will kick down . All vacuum lines look good it’s...
  3. Patrick Reeve

    Th350 has to warm up before moving and more

    Vortec* sorry lol
  4. Patrick Reeve

    Th350 has to warm up before moving and more

    Fluid level is fine and I’ve tried adjusting the modulator and still didn’t change anything The motor has Bowtie phase 2 heads non vortex and a air gap intake Is there any certain way to test for a bad torque converter ? Tach might be a light off but I don’t think it’s too bad
  5. Patrick Reeve

    Th350 has to warm up before moving and more

    1981 C10 with a 383 and th350 It has to warm up for at least a few minutes in 30-40 degree weather. not as bad in warmer weather but still takes some time. It also seem to shift fast like it’s going about 25 and already in 3rd gear And finally the trucks has 3.42s with 295/59/15s tires . At...
  6. Patrick Reeve

    Clutch fork not moving much

    Bought a 86 k10 that had set for about ten years . I’ve got it running again but the clutch just goes to the floor. So I’ve got a new master and slave because both are leaking but tried moving the clutch fork and it was stuck . Took a hammer and just tapped it to free it up (probably shouldn’t...
  7. Patrick Reeve

    New member iso of advice

    OK thanks appreciate it
  8. Patrick Reeve

    New member iso of advice

    Glad to be here but got a couple questions. I have a 86 k10 with a clutch problem. What sections do I need to post in ? Thanks

Latest posts

Forum statistics

Threads
42,109
Posts
909,277
Members
33,595
Latest member
T3rraBeara
Top