fishwater
Junior Member From New Hampshire
- Joined
- Last seen
- Viewing thread 8.1 Vortec VS 383 Stroker VS 6.0 Iron LS
Latest activity Postings About
-
-
fishwater replied to the thread Vacuum Advance Limiter Plate for HEI Distributors.Great idea, simple clean set up! -
fishwater reacted to sukhoi's post in the thread Vacuum Advance Limiter Plate for HEI Distributors with
Like.
Howdy Friends, If you drive a V8 with a distributor and want to save money on gas, read this! Okay clickbait aside... Kind of a niche... -
I need to replace the exhaust in my ‘76 Jimmy and looking for recommendations. According to Summit the Dynomax/Walker kit, part# 89007...
-
In your initial post, are you saying you’ll use your current intake manifold that’s on the 305 on the Tbi motor? If you are ordering a...
-
^^^ center 4 bolts are different angle on your 305 than on TBI heads you can grind the holes to the correct angle otherwise you are...
-
fishwater replied to the thread TBI Motor Swap.Both have torque down low where needed and max out at 5400 RPM like the old RV/Tow style cams. .462/.480-218/226 @50 with 111...
-
Look at the rpm where they make power in relationship to where you are going to spend most of your time driving. 410 horsepower at...
-
fishwater replied to the thread TBI Motor Swap.I’m looking at two different budget 383 builds, both are 9.5 or 9.0 compression. One is fancier with stainless valves and Melling HV...
-
You may not have to cut the arm. See if the relief is cast into the block just no pushrod hole drilled.
-
fishwater replied to the thread TBI Motor Swap.That’s brilliant, so you cut the arm off of the pump and bolted it to the block so it looks factory?
-
fishwater replied to the thread TBI Motor Swap.Thanks, I just bought it with the understanding that it had the original 400 but after driving it I realized it was a little under...
-
-
I had to click a few times on your avatar to see the wide screen shot: but that is a mighty fine looking thing to be putting a hotter...
-
You may not have fuel pump provisions on the TBI block,probably will not. So an electric pump will ne necessary. When I did mine I...
-
I’m going to replace the tired 305 in my 76 Jimmy with a rebuilt 383 TBI roller motor, anything to worry about, like will the...
-
fishwater replied to the thread K5 K10 17x8 or 17x9 vision Cheyenne Aluminum rally wheels?.What lug nuts did you end up with? Extended length or acorn/bulge?
-
-
Loading…
-
Loading…
