Recent content by Branktm
-
A/C Question regarding different years
Got truck with engine completely missing, so haven't touched anything on the heat and A/C side until right now after truck is drivable. Got a new heater core in today because when all the lines were hooked up, it shot coolant through and leaked and stained my just installed carpet. oopsie on my... -
A/C Question regarding different years
I had to change fans because the stock one ran clockwise and didnt push air, but now a counterclockwise fan is operating correctly. I am actually put a clutch on the fan this weekend cause its still running hotter than id like in this summer heat Anyways here are some pictures Picture 1 and 2... -
A/C Question regarding different years
I have a 76 K15 Sierra Grande that came with factory air. I have a fresh SBC 383 stroker in it but I added a serpentine belt system from a 92. meaning it runs counter clockwise. Had to change fans, alter the alternator etc. The belt system still has the 92 compressor on it, im sure its junk. I... -
Detroit steel wheel delreys on 37s
Got the cab and bed on this weekend.- Branktm
- Post #4
- Forum: Wheels and Tires
-
Detroit steel wheel delreys on 37s
Happy how this turned out. Here is side by side stock 15inch rallys vs 18x9s with 37x13.50s.- Branktm
- Thread
- Replies: 8
- Forum: Wheels and Tires
-
Diagram for fuel lines on a 76 K15?
Also have a new painless wiring harness that is supposed to be specifically fitted for all 73-87s so i assume it should have everything to make a 6 port work- Branktm
- Post #8
- Forum: Carb Fuel Systems
-
Diagram for fuel lines on a 76 K15?
Ok so return the 3 port selector valve i got off lmc and get the 6 port then. Guess it doesnt matter really its not original motor anyways plus the selector valve had some uncomfortable warnings on it. Like not intended for oe replacement and offroad only. And just find a T from any where that...- Branktm
- Post #7
- Forum: Carb Fuel Systems
-
Diagram for fuel lines on a 76 K15?
Got all my fuel hoses and clamps bought based off your diagram, got the lmc steel cross over lines all 3 of them. Planned and knocking this out today but was thrown off by 2 things. One my new tank selector valve is a 3 port not a 6. And on the vent hose you have a T that splits the 5/16 line...- Branktm
- Post #5
- Forum: Carb Fuel Systems
-
1976 K15 Crossmember Question
Oh here are pics of what im talking about- Branktm
- Post #5
- Forum: Transmission & Transfer Case
-
1976 K15 Crossmember Question
Yes right concept but all one piece, not bolted on. Either way i called rough country who made the drop kit for the transfer case. Advised me that i didnt need to bolt in the sides and move on. I however drilled two holes into the frame to put bolts back in. But i also got a 3/16 metal plate...- Branktm
- Post #4
- Forum: Transmission & Transfer Case
-
Diagram for fuel lines on a 76 K15?
Yes it is the 3 port for the tank and the fuel pump. I dont recall a vapor canister but again it was previously converted to propane and the saddle tanks were just capped off. It had a massive tank in the bed with a line running under the cab. Thank you for the diagram. Question, the lines after...- Branktm
- Post #3
- Forum: Carb Fuel Systems
-
New brake upgrade on the frame off restore
Took me a while to pull the trigger on these. Just felt weird buying caliper replacements for super cheap on a frame off build. Spend all this money on everything, lift it to the sky with 37s and have $30 calipers to stop it? Anyways it was $30 or $400 for these, since there wasnt much of a... -
1976 K15 Crossmember Question
Just got the Tranny and transfer case back from rebuild. Its a turbo 350 tranny and the heavy 208 transfer case. I also bought a transfer case lowering kit from rough country to go with the lift. But from what i see it just lowers down the crossmember by 4 spacers. The weird think is my cross...- Branktm
- Thread
- Replies: 6
- Forum: Transmission & Transfer Case
-
Diagram for fuel lines on a 76 K15?
Does anyone have a diagram or a reference point of where I can review how all my fuel lines go on my 1976 K15? I am in the middle of a frame off restore. and just got new saddle tanks and fuel sending units (3 outlets) in. The truck was previously set up to run off propane (new engine on order)...- Branktm
- Thread
- Replies: 8
- Forum: Carb Fuel Systems
-
Rough Country 6inch lift dumb question
Hey guys, just got my frame back from the powder coaters, and my rear end is "curing" for the 48 hours of Eastwood Encapsulater. So since I finally got my 6inch Rough Country all spring lift in last week, i decided to start putting everything back together. I literally have the frame on a few...- Branktm
- Thread
- Replies: 2
- Forum: Lifted & Off-Road Systems
