J
JBswth
Latest activity Postings About
-
-
JJBswth reacted to Chevy 88's post in the thread Pretty sure I blew a head gasket this morning.... with
Like.
I think that based on all of the info so far, I would suggest this: Remove the thermostat. Run the engine with the radiator cap off... -
JJBswth replied to the thread Are these modern carburetors a big improvement?.One guy got a super-rare 58 DeSoto FI Adventurer. He reverse-engineered that FI and realized that the transisters, etc. just couldn't...
-
JJBswth reacted to PhotonFanatic's post in the thread Are these modern carburetors a big improvement? with Like.
It sounds as though the carb is fundamentally pretty darn limited and fuel injection should be used for greater accuracy and elimination...
-
JJBswth reacted to Ricko1966's post in the thread Are these modern carburetors a big improvement? with Like.
AI stuff you gotta dig deeper. A lot of the decrease in cylinder wear is better metallurgy,low tension rings,better understanding of rod...
-
JJBswth replied to the thread Are these modern carburetors a big improvement?.If they succeed in shutting CARB down, that will change.
-
JJBswth reacted to Finkaire's post in the thread Are these modern carburetors a big improvement? with Like.
Not available in California
-
JJBswth reacted to Rustisbest's post in the thread Are these modern carburetors a big improvement? with Like.
Unless you have a stock engine with the carb that came on it from the factory they all have to be tuned for the application. They only...
-
JJBswth reacted to TotalyHucked's post in the thread Are these modern carburetors a big improvement? with Like.
I'd agree with Spencer on this one. A carb is a carb, period. There's not much to improve upon vs years ago. My dad has spent time with...
-
JJBswth reacted to legopnuematic's post in the thread Are these modern carburetors a big improvement? with Like.
In my opinion, no they are not. A carburetor in its fundamental sense is using the same principles regardless of if it says Holley...
-
JJBswth reacted to 75gmck25's post in the thread Are these modern carburetors a big improvement? with Like.
Cylinder wear issues have been significantly reduced because most modern EFI systems keep AFR within very close limits. Modern...
-
JJBswth reacted to PhotonFanatic's post in the thread Are these modern carburetors a big improvement? with Like.
Are modern carbs from Holley, Edelbrock, Demon, etc a big improvement over stock stuff from the 70's and 80's? One assumes there would...
-
JJBswth reacted to AuroraGirl's post in the thread Big block running hot. Can’t figure out the issue with Like.
-
JJBswth reacted to 75BEASTK20's post in the thread Big block running hot. Can’t figure out the issue with Like.
I'd start with checking rad first for circulation or any kind of blockage. Then check thermostat to make sure it opens. Even NEW...
-
JJBswth replied to the thread Big block running hot. Can’t figure out the issue.Are you sure that your vacuum advance is supposed to be using manifold vacuum and not ported vacuum? J. B.
-
JJBswth reacted to Slooptin's post in the thread Big block running hot. Can’t figure out the issue with Like.
Cruise is around 14-15. Idle is 11-12. It gets hot whether I drive it around or not. Not sure on total timing. Vac advance is hooked up...
-
-
Loading…
-
Loading…
