Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
Just sloppy when I applied. Never meant for it to be on thereius the yellow being wiped away on the "top" of the gear meshing interface too much or did you not directly wipe it on the top oonly on the faces? I guess I dont know how close that stuff is when its meshed
These are a new set of gears and carrierRemember, this is the drive side:
You must be registered for see images attach
The drive side, most important, coast side, not so much. The pinion could be a little deeper, because the pattern runs off the edge.
Are these used gears? The pattern is good, run it!