M
MtBraun
Latest activity Postings About
-
-
MMtBraun replied to the thread Sanderson Headers question.Thanks for the pics. Looking at these for a tall deck 632. It appears from your pics there may be space, but what do you think?
-
M@QBuff02 here's a bunch of pics of the Sanderson's in my Blazer (454 w/ K30 oil pan, hydraulic 4spd w/ support bars, Off Road Design...
-
MMtBraun replied to the thread WTB TCase Crossmember.It appears that a th350/np203 cross member will also work, if anyone has one available.
-
MI need a transfer case frame cross member for a TH400/NP205 for my '84. I am using the tall figure 8 transfer case pedestal. Thank you
-
MMtBraun replied to the thread D44 longer Wheel Stud P/N needed.Thanks for the background. I was reading content on other sites (perhaps uninformed) that said I would need longer studs with a wheel...
-
MMost aftermarket aluminum wheels have the mounting holes countersunk into the face of the wheel, even the old mag wheels used the shank...
-
MMtBraun replied to the thread D44 longer Wheel Stud P/N needed.Correct, 8 lug. I don't see how the stock length of 2" will be long enough for aftermarket rims.
-
MI don't think the stock length D44 9/16-18 studs (2") will be long enough for aftermarket aluminum rims. I'm looking for verification...
-
MMtBraun replied to the thread Need gear pattern feedback.Backlash was at .009. I ended up adding a .005 pinion shim and it patterned well. That did decrease backlash to .006 but since it was...
-
Mthis unless you spend mucho bucks for custom rear springs, lifted leaves will ride worse than your stock leafs. one thing to think about...
-
MMtBraun replied to the thread Need gear pattern feedback.I was able to get more resistance and a better pattern. High on the drive side, good on the coast side. I think pinion need to come in...
-
-
MMtBraun replied to the thread Need gear pattern feedback.With that in mind, how does the coast pattern look? I think it’s pretty close.
-
MMtBraun replied to the thread Need gear pattern feedback.Any suggestions on resistance? I'm turning with the yoke holder and using my other hand with a glove to provide resistance against the...
-
MSetting up my first diff, front D44 on this build. First pattern, (not pictured) showed contact angled across the root and coast side...
-
-
MMtBraun replied to the thread Pinion Depth Tricks.Me neither, lol, but that's what the diagram shows. Check that out on my earlier post. And since East Coast Gear (probably others too)...
-
-
Loading…
-
Loading…
