Seege
Junior Member
- Joined
- Sep 18, 2022
- Posts
- 8
- Reaction score
- 7
- Location
- Southern California Desert
- First Name
- CJ
- Truck Year
- 1973
- Truck Model
- c10
- Engine Size
- 6.0
My project truck was lowered by the previous owner and is way too low for me in the rear with a bunch of rear-end sag. Front end height is good. He C-notched it and used 1'-2' drop hangars. I put stock hangars back on it and gained back 1.5 inches. I still need almost 4 more inches. I need to get this done so I can get the new driveshaft length dialed. I can't see any way to raise it other than flipping the axle back and then using the drop hangars again. The question is, can I simply reverse the flip? Theres a block between the axle and leafs and I'm wondering if that existed originally or was part of a flip kit? I'm worried if I simply flip it, it's going too high. Thanks