Crispy
Full Access Member
- Joined
- Apr 5, 2017
- Posts
- 1,454
- Reaction score
- 1,391
- Location
- Carbon County, Pennsyltucky
- First Name
- Chris
- Truck Year
- 1989
- Truck Model
- Suburban V1500
- Engine Size
- 5.7
So I finally got my burb buttoned up after the head gasket swap. It fired up and idled on the first shot after I finished reassembly. I let it run for only a minute or so since I didnt put coolant in yet. After filling the cooling system I started her back up and ran it till the thermo opened and circulated the fresh coolant. A few minutes after it started idling rough and shut down. Now it just cranks and wont start. I'm not getting a check engine light. Any clues? Or suggestions on where I can go from here?
Prior to final reassembly the valves were adjusted (probably not 100% as they sounded a little chattery but close)
Distributor was pointing to cylinder 1, with engine at TDC. Cap went on in relation to the dizzy.
Thanks in advance.
Prior to final reassembly the valves were adjusted (probably not 100% as they sounded a little chattery but close)
Distributor was pointing to cylinder 1, with engine at TDC. Cap went on in relation to the dizzy.
Thanks in advance.