projo198
Latest activity Postings About
-
-
projo198 replied to the thread Coolant Hose Popped Off the Thermostat.Because of the low cost I would go ahead and replace the hose, thermostat, coolant and radiator cap. As for coolant in the carb may be... -
projo198 replied to the thread Shop heater.I built a double 55-gallon drum wood stove for mine, but honestly I mostly run my huge Val 6 that burns diesel which I fill with...
-
projo198 replied to the thread Harbor Freight Table and carts.I have one and love it. Unfortunately like anything horizontal in my shop it typically ends up piled up with crap and unusable...
-
projo198 replied to the thread Instrument cluster questions on new build.This may not be of great use to you, but I had the same issue a few years back finding the correct temp sensor for my '82 with a 305...
-
projo198 replied to the thread Do I even need a gas tank vent tube?.Well I feel dumb. The vent hose had in fact kinked behind the fill tube. Instead of paying $25 for the correct hose I just added a brass...
-
-
projo198 replied to the thread Do I even need a gas tank vent tube?.Thank you. The hose still has a downward angle but likely not enough like you said. I will do some research on the blazer tank, have not...
-
On my '78 K10 when I replaced a leaking gas tank I moved the mounts up so that the tank didn't hang so low below the body. In doing so I...
-
projo198 replied to the thread A Technical Comedy [Only After the Fact].Good call on not breaking your wife in the process. They don't handle a lot of voltage well!
-
projo198 replied to the thread Should the windshield wipers park on a 1974?.Good luck, let me know if you need help, just finished chasing this issue on my own truck and took me a while to get it right.
-
projo198 replied to the thread Power Steering Squeel.Aside from the belt/pully conversation have you checked for air in your system? Run it, shut it off and pop the reservoir cap to see if...
-
projo198 replied to the thread Exhaust Question.Late to the conversation, but if you can weld dual exhaust is very easy to run and Flowmaster's patent on their 40 series mufflers ran...
-
projo198 replied to the thread '78 K10 radiator overflow plumbing.Thank you. Hot it installed over the weekend, there is an overflow opening on the tank that is left open but I wasn't accounting for the...
-
PO did not have an overflow tank and the hose attached to the radiator just below the fill shoots coolant out when hot. I looked up the...
-
My '78 K10 is very lifted, and I recently added crossover steering which required removal of the sway bar. I am on the verge of having...
-
projo198 replied to the thread 1987 GMC Jimmy 4x4 6" lift body mount bushing replacement.<Nailed it. I used poly spacers and they installed very well.
-
-
Loading…
-
Loading…
