Search results
-
S
20" tire
offsets What are your offsets on the front and rear?- sc2665
- Post #4
- Forum: Wheels and Tires
-
S
Aftermarket Brake Lines
I just finished rebuilding the front suspension on my 84C10 and installing a set of 3" drop spindles. Decided to replace the calipers and brake lines while it was apart. The O.E.M. style brake lines will not bolt to the caliper with the new drop spindles. Can anyone recommend a good set of... -
S
oil pressure sender 84 c10
Had to do a little engineering because the gauge sensor is short and fat and 1/8" instead of 1/4" but its in and working. Thank for the help Robert. Now onto the volt meter!!!- sc2665
- Post #9
- Forum: Engine & Performance
-
S
oil pressure sender 84 c10
I think that may be where the 3 wires are coming from. I will take a look this weekend. Thanks- sc2665
- Post #8
- Forum: Engine & Performance
-
S
oil pressure sender 84 c10
OK finally had the time to pull the idiot light sensor out and put the gauge sensor in. IT WONT FIT!!! The holes are the same size and thread BUT I have an Edelbrock in take and a MSD distributor. The Intake sits higher than the stock one and the distributor is wider than the stock. Im trying...- sc2665
- Post #6
- Forum: Engine & Performance
-
S
oil pressure sender 84 c10
no not plugged into anything. wires were cut and taped. the wire to the gauge was cut and taped too.- sc2665
- Post #3
- Forum: Engine & Performance
-
S
oil pressure sender 84 c10
I recently bought a 84 c10swb. The PO replaced the motor but didnt hook up anything for the gauges or grounds. I have checked the gauge and it works. I have installed new grounds for the engine block and to the cab. I have looked all over the block and only found the 2 prong oil sensor on top...- sc2665
- Thread
- Replies: 9
- Forum: Engine & Performance
-
S
good brand for powerfull windows motors
Instead of WD40 get some silicone spray lubricant. Where did you get those connectors for the stock switches?- sc2665
- Post #13
- Forum: Electrical & Audio
