Search results
-
no fluid to right caliper
It was the hose, what a pain in the butt when it's rusty- curse
- Post #14
- Forum: Suspension, Steering & Brakes
-
no fluid to right caliper
Makes sense, i've never seen or had a hose go bad by swelling. Maybe I finally will.- curse
- Post #13
- Forum: Suspension, Steering & Brakes
-
-
no fluid to right caliper
I'll unhook the hose where I have metal line and see what happens. It did sit over 3 years. When I unhooked the line from the caliper I expected some fluid, even if not a lot, but I didn't get 1 drop. With the line unhooked I had my neighbor push the pedal and there was still nothing. I was...- curse
- Post #5
- Forum: Suspension, Steering & Brakes
-
no fluid to right caliper
I know the proportioning valve balances the fluid front to back but can a bad valve block fluid to right front caliper? Fluid gets to the rears. Master cylinder leaked and I replaced it.- curse
- Thread
- Replies: 17
- Forum: Suspension, Steering & Brakes
-
-
-
-
-
problem getting 350 started
The cause is my forgetfulness and I must have not adjusted them- curse
- Post #122
- Forum: Engine & Performance
-
problem getting 350 started
Oh yeah...I still had a high idle and the idle screw was all the way out. So I pushed the arm that throttle cable mounts to see if the idle would go lower. Something let loose and the idle dropped way down and I had to adjust the idle screw, something was bound up. Much better now- curse
- Post #118
- Forum: Engine & Performance
-
-
problem getting 350 started
So yeah, 2,4,6,and 8 valves not operating like they are supposed to. The drivers side was good.- curse
- Post #116
- Forum: Engine & Performance
-
problem getting 350 started
I have no clue what happened here other than I got sidetracked and only did the drivers side.- curse
- Post #115
- Forum: Engine & Performance
-
problem getting 350 started
I'm trying to get vid off phone so bear with me- curse
- Post #114
- Forum: Engine & Performance
-
-
problem getting 350 started
Correct on even number but #'s 2,4,6,8- curse
- Post #111
- Forum: Engine & Performance
-
problem getting 350 started
I'm out of state and busy. I'll reply later.- curse
- Post #110
- Forum: Engine & Performance
-
-
problem getting 350 started
More noticeable on drivers side, I pick #5- curse
- Post #100
- Forum: Engine & Performance
-
-
problem getting 350 started
It seems to have a slight misfire, kinda intermittent??- curse
- Post #95
- Forum: Engine & Performance
-
problem getting 350 started
Unfortunately my job is sending me to Pittsburg for a week so I will have to pull the valve covers after next week. I wondered if I bent a valve or 2 or a push rod when I blew the mufflers apart.- curse
- Post #94
- Forum: Engine & Performance
-
problem getting 350 started
Hopefully this will help. I removed the fan so I could get closer without the air noise.- curse
- Post #90
- Forum: Engine & Performance
-
problem getting 350 started
You can rattle off more thoughts, I appreciate it. I could always write my issues on paper but posting them here might help others. I'll pull the fan off the motor and see if I can get a better vid without air noise.- curse
- Post #89
- Forum: Engine & Performance
