Recent content by Sachmo

  1. Sachmo

    Long tube headers

    I'm running the summit brand headers on my 83 and they clear just fine
  2. Sachmo

    motor mounts

    Motor mounts won't affect power. mainly just notice the engine rock more when given throttle. A loss of power and vibration sounds like a dead cylinder
  3. Sachmo

    Rebuildable 208?

    I pulled my trans thinking that it had went out but upon seeing that it was in good shape i turned my attention to the 208. cracked it open and found one heck of a mess on the magnet. Looks like the input bearings went and allowed the shaft to slide forward and start grinding into the case. I'm...
  4. Sachmo

    Sm465 noise

    Anything seem out of the ordinary? the picture of the smaller gear at the bottom of the tranny makes noise if i spin it.
  5. Sachmo

    Sm465 noise

    Well yesterday the trans went out. Nothing in any of the gears. It is now pulled apart, but i don't know what to look for. The only thing i see wrong is that i can wiggle the input shaft. i'll see if i can post a picture.
  6. Sachmo

    Sm465 noise

    Is there a set of gears connected to the output shaft that are always in contact? It seems too rhythmic to be a bearing. I could be wrong though
  7. Sachmo

    Sm465 noise

    Definitely related to speed. Other than the noise it drives fine. Doesn't pop out of ear or anything weird. Is a press needed to replace the output bearing?
  8. Sachmo

    Sm465 noise

    The other day while driving my tranny started making a whirring sound. I know it is full of fluid because i just replaced the clutch. It has now become more of a rattle. It makes noise only when moving. clutch in/out whether it is in gear or not. any ideas as to what wore out?
  9. Sachmo

    Time for a new clutch

    New clutch is in, and she's driving as good as ever. Ended up getting the flywheel resurfaced for 25 bucks at south bend clutch. Napa wanted 55 to do the same work! I came across that thread before i put the clutch in. boy what a help that was! thanks irishman
  10. Sachmo

    Time for a new clutch

    Well its time to put in a new clutch. I've never replaced or even worked on a clutch before so any tips would be much appreciated. I'm looking for a stock replacement clutch such as this http://www.summitracing.com/parts/zzz-mu5505-1 . would this be the correct clutch for my setup? also i'm...
  11. Sachmo

    weird coil issue on ski doo

    alright so i got an old ski doo everest 500 from a friends barn. It had been sitting for who knows how long, so i decide to do a full rebuild. New crank seals, gaskets, pistons rings. trouble is i only get spark on one cylinder at a time. if both coils have the positive leads hooked to them only...
  12. Sachmo

    engine missing when given gas

    plugs all looked okay. it has new wires on it and the cap and rotor looked okay as well. she idles just fine. could running on just the primary circuit of the carb cause this? the pop comes from the exhaust. maybe the distributor moved? i dont have a timing light to check it though
  13. Sachmo

    engine missing when given gas

    Alright guys. My dd is acting up on me. Stock 350 with a quadrajet. When pulling off the highway today my truck lacked power and would sputter when trying to accelerate. I pulled over and revved the motor to a sustained rpm around 3000 and it would miss randomly and pop on occasion. I checked...
  14. Sachmo

    Brake issue

    I had to replace the master cylinder on my truck a few weeks ago. Thing is when i got the new one on the brake lines did not fit in the previous spots. the line that was in the front only fit into the rear spot and vice versa. I then had a wheel cylinder go bad 3 weeks later, so i replaced...
  15. Sachmo

    New H1 24 bolt wheels for the K5

    I don't know about the spacer but those are going to look SWEET man. :headbang:
See more

Latest posts

Forum statistics

Threads
42,292
Posts
913,062
Members
33,791
Latest member
krogers98gmc
Top