Recent content by Franken Chevy
-
F
bye bye tow hooks. any suggestions?
Hey guys I have a 2003 chevy 1500 that I recently pulled the tow hooks out of the frame on. Any ideas on what to do. Thx- Franken Chevy
- Thread
- Replies: 0
- Forum: Other Vehicles
-
F
no more tow hooks
It says I ripped the hooks out of the frame.- Franken Chevy
- Post #3
- Forum: Other Vehicles
-
F
no more tow hooks
friend got stuck so i went to pull him out. got him out but at the cost of ripping one tow hook out of the frame. then i got stuck and he pulled me out at the cost of the other tow hook. still have them both, can i just weld them in? or what should i do or have done? thx- Franken Chevy
- Thread
- Replies: 5
- Forum: Other Vehicles
-
F
re-seal top half?
Ill half to look. I personally dont have one but I have access to one. Ill have to give that a try too- Franken Chevy
- Post #6
- Forum: Engine & Performance
-
F
everything and anything
Just talked to my friend, guess the ignition system is still in use. They just bypassed the key- Franken Chevy
- Post #13
- Forum: Electrical & Audio
-
F
everything and anything
Im not sure the splicing logic. I was not involved in that at the time- Franken Chevy
- Post #12
- Forum: Electrical & Audio
-
F
everything and anything
Yes motor is free. If you bolt it up and stick a screw driver it will turn the starter over. The true issue is that when you hit start button, you lose all power, do I possibly need another ground? Maybe because I have it grounded to the starter which has power it isnt truly grounded?- Franken Chevy
- Post #9
- Forum: Electrical & Audio
-
F
re-seal top half?
Ok thx ill have to check that out- Franken Chevy
- Post #3
- Forum: Engine & Performance
-
F
re-seal top half?
have a sbc 350 out of a 1978, it is bored to a 355, with a couple goodies on it. after running it the there day i noticed a little coolant pool on top of the intake. is this normal? the truck itself isn't put together right but the motor is. any help? thx- Franken Chevy
- Thread
- Replies: 5
- Forum: Engine & Performance
-
F
everything and anything
Yes it does spin. Im not sure because im not looking at it right now. I believe its positive, spliced into an old ignition wire, ignition wire to the starter, the positive from starter to battery, it may also be positive right to the starter, then positive from starter to battery, also I believe...- Franken Chevy
- Post #6
- Forum: Electrical & Audio
-
F
everything and anything
Is this for the guages or to start it? Check the cables for what? Make sure there is no short in them? Make sure there is enough resistance in them? We have power everywhere, until you hit the button. Once you hit the button you lose all power- Franken Chevy
- Post #3
- Forum: Electrical & Audio
-
F
everything and anything
My friend bought a "1986" square body that has been chopped a couple times. The frame is an unknown year. The motor is a 1978 350 bored to a 355, and the cab is off of a 1986 that was a 2wd 305, rear axle is a dana 80 with a 4:35 ratio, the front I believe is a 12 bolt with 4:35's as well...- Franken Chevy
- Thread
- Replies: 16
- Forum: Electrical & Audio
-
F
2003 chevy trailer light hook-up
Accidentally ripped my wires out of trail light connector. Wondering if anyone has a diagram for how they go back jn I cant seam to find. Thx- Franken Chevy
- Thread
- Replies: 0
- Forum: Other Vehicles
