Recent content by Doug80
-
D
Carb help
Ok I have an 80 k10 350 motor that was rwbuilt over 5 year ago. Most likely 10yr. Owner before me said he rebuild it out a mild cam in and bored it .30 over I believe. No paperwork but doing a compression test they were all at 145-150. So would a holly 650cfm work or would an 600cfm work? I...- Doug80
- Thread
- Replies: 10
- Forum: Carb Fuel Systems
-
D
New Vacuum lines
THANK YOU!!!! The last one is what I was looking for. I figured someone would know what I was talking about and were to find it. -
D
New Vacuum lines
Ok going to be running new vacuum lines for the heat and stuff and would like to know if anyone has a diagram of what num go to what vacuum line for the vacuum module. I already found one that shows what and we're all the lines to and stuff but I do not know what vacuum lines go were on the module. -
D
Anybody use these headlights?
If anyone has how were they? Any good, and do they out out more light than/better light pattern than stock sealed beams?- Doug80
- Thread
- Replies: 11
- Forum: Aftermarket Accessories
-
D
Lift kit swapping
It's a rough country complete lift blocks rear new springs up front raised steering arm new shocks would it still be 4in on the blazer?- Doug80
- Post #3
- Forum: Off-Roading
-
D
Lift kit swapping
Can a 1980 k10 4in lift work on a k5 blazer? If so what years would it work on and would it still be 4in or would it be higher or lower?- Doug80
- Thread
- Replies: 5
- Forum: Off-Roading
-
D
205 tcase help!!!
Ok guys I got the gaskets and everything I need but I was wondering what is the tq for the nut that is on the shaft coming out of the tcase that holds the flange the driveshaft bolts to? Having issues finding it?- Doug80
- Post #7
- Forum: Transfer Case
-
D
205 tcase help!!!
Would this seal kit give me the gasket I need that sit against the tcase and the flange http://m.oreillyauto.com/mt/www.oreillyauto.com/site/c/detail/FEL0/TS80332.oap?pt=03166&ppt=C0316- Doug80
- Post #2
- Forum: Transfer Case
-
D
205 tcase help!!!
Ok my tcase is leaking at the front output I already found the one seal I would need that is round but I need to know part numbers and names for the second one. It pretty much looks like a carb gasket that goes between the carb and the intake. Any info/help would be greatly appreciated.- Doug80
- Thread
- Replies: 7
- Forum: Transfer Case
-
D
Which do you prefer??
^^^x3 lol its cool but I would not want it.- Doug80
- Post #34
- Forum: Off-Roading
