1
1STLS1
Latest activity Postings About
-
-
11STLS1 replied to the thread Best deal on leaf springs?.I have been told a local spring shop can re arch and rebuild them cost effectively but never tried it.
-
11STLS1 replied to the thread Heat temp gun/correct temp sensor/etc..The fact it gets warm on the highway suggests it's a flow issue in the radiator or it's too small of a radiator. Also verify the cap is...
-
1Take a piece of wood and set it on the emblem. Whack it with a hammer so that it breaks the studs. Install the new emblems with barrel...
-
11STLS1 replied to the thread Tonneau covers for short bed stepsides?.I bought a Craftec one for my '87 GMC . It's never been on the truck because it's a work in progress but it's assembled and looks good...
-
11STLS1 replied to the thread New here from AZ.Hello from down the 303 in Goodyear
-
11STLS1 replied to the thread Best gun for metallics.Is that a factory color? Does it match the paint code on the SPID?
-
1Check out utube chanel (Paint Society ) Guy is knowledgeable and keeps it simple.
-
11STLS1 replied to the thread Best gun for metallics.I read your post and looked at what your painting and an honest answer is your technique and air pressure will make more difference than...
-
11STLS1 replied to the thread Dent removal.This is a video where a guy uses several glue sticks and a propane torch to heat them to pull a dent, fast forward to 2:30 where he...
-
11STLS1 replied to the thread Stepside Fender and Step attachment Question..The factory seam sealed them together then had a quarter round bead to keep debris out of the top of the mating area, you may need to...
-
-
11STLS1 replied to the thread Procomp 69 center caps.I am not sure of the inside diameter of your wheel but 4.25" is somewhat standard, please verify before searching. I ordered a pair from...
-
-
Loading…
-
Loading…
