Recent content by carpart67

  1. carpart67

    86 High Sierra - Spindle Studs

    I'm starting to replace the front left ball joints on my 1986 High Sierra. Truck is half ton 4wd. Just wondering if anyone could tell me if the studs that hold the spindle on are threaded or pressed in. I've got the rotor/hub removed and the nuts/studs behind it that hold the spindle on are...
  2. carpart67

    Module on valve cover? (1986 GMC 350)

    Turbo 350 If I get a chance to clean it up I will post the colors.
  3. carpart67

    Module on valve cover? (1986 GMC 350)

    Not a lot. No cruise, or anything. Perhaps it's something to do with emission control? The truck is Canadian and did have an air pump and all that jazz.
  4. carpart67

    Module on valve cover? (1986 GMC 350)

    Lol, yes it does. Wondering what for though.
  5. carpart67

    Module on valve cover? (1986 GMC 350)

    Here she is
  6. carpart67

    Module on valve cover? (1986 GMC 350)

    I will try to snap one tonight
  7. carpart67

    Module on valve cover? (1986 GMC 350)

    I plan on swapping the valve covers on my 1986 High Sierra. The engine is the original 350. The drivers side valve cover has some sort of relay or module clipped to it with wires running to it. Just wondering if anyone could tell me what it is? I'd like to get some info so I can figure out...
  8. carpart67

    Selector valve removal

    Well I did switch it a few times and was able to start the truck on the pass side tank. Not so worried now I had planned on removing all that gear anyway, at a later date but I was able to get at it this morning. Pass tank is out, selector valve is out. Now I just need to couple my lines...
  9. carpart67

    Selector valve removal

    Is it possible I caused the problem myself? I didn't hold the valve when switching to the left tank, I didn't realize I had to? I still plan to remove the valve sometime but if I can buy some time before getting to it that would be great.
  10. carpart67

    Selector valve removal

    I plan on switching my truck to single tank. Conveniently enough my selector valve just went on the fritz. The return line has been feeding into the opposite tank than the fuel pump is pulling from. Couldn't understand where all my fuel went. Just wondering how the fuel lines connect to...
  11. carpart67

    Side tank removal

    I'm not going to use the plastic shield again. I've got a set of brackets in good shape, new straps, a fairly new tank, and am working on sourcing something for anti-squeak pads, and longer line. So really all I've got to do is clean and paint the parts, test the sending unit, and to put it...
  12. carpart67

    Side tank removal

    Alright thanks.
  13. carpart67

    Side tank removal

    Are they necessary? They weren't on the parts truck. And thanks for the drawing!
  14. carpart67

    Side tank removal

    Thanks guys. I removed the tank from my parts truck. It's only a few years old and in good shape. I took the whole bracket/strap assemble off together at the same time still attached to the tank. It looks to be the same size as the tank on my driver so I'm going to use the brackets,straps...
  15. carpart67

    Side tank removal

    Fuel tank brackets and removal Excuse my stupidity but I'm fairly new to these trucks. I have an 86 High Sierra with dual tanks. It looks to me like they are held in with large "C" shaped brackets that wrap around the bottom of the tank. One of the tank brackets on my truck has rotted. Also...
See more

Latest posts

Forum statistics

Threads
42,208
Posts
911,367
Members
33,713
Latest member
87R10_Cruising
Top