CalSgt's latest activity
-
CCalSgt reacted to Jrgunn5150's post in the thread Jeep JK Conversion - Farm beater / Grocery getter with
Like.
They were 3.8 from 08-11, 3.8 from 12 on. Never a 5 speed, was a 6 speed. Again, wouldn't pay Jeep tax for a running one. Not when... -
CCalSgt replied to the thread Jeep JK Conversion - Farm beater / Grocery getter.The 3.6L JK's are fairly reliable and were commonly sold with a 5 speed standard gearbox, if you find one you might consider driving it...
-
-
CCalSgt replied to the thread Tailgate trunnion hinge repair.How's about some pictures
-
CCalSgt replied to the thread LMC Vent Window Rebuild.Wish I would’ve known to get the precision setting tape ahead of time. Setting tape was the main thing I fought on the side glass too
-
COkay - I got them done, and yes it is a pain in the ass! The biggest lesson I can pass on is to order everything from Precision, not...
-
CCalSgt reacted to legopnuematic's post in the thread Strange thing with ball joint on k20 with Like.
Was the upper sleeve adjusted properly during install? The upper and lower joints are in compression in normal loading. That’s all I...
-
CWhen doing work under the dash disconnect the battery.
-
CWhat are you trying to replace? I believe the standard GM fusible link is a 14 gauge link for a 10 gauge wire. You should be able to...
-
CThanks for the info. I picked up a cable from a 6.2 diesel That looks like it may be just right but I’m waiting on a carb swap before...
-
CCalSgt replied to the thread Throttle cable correct?.Not cheap but this is the cable I ordered for my truck, may be trimmed to length & they have a few different options for what type of...
-
-
CMakes sense, there must have been a design weakness. K cases had those two additional braces that are a PITA to install and always in...
-
CYeah, maybe.......I guess all my sh!t is gonna break........ :shrug:
-
CCalSgt replied to the thread NP241 TRANSFER CASE SUPPORT ROD.I think GM solved the issue with the LS platform because they don’t have them on the GMT800’s…. Full bell housings that bolt into cast...
-
CTorque is your enemy here. Aluminum bell housings both automatic and manual really aren't that strong. I had to replace bell housings on...
-
CCalSgt replied to the thread Transfer Case shifter ROD vs Cable? What are people using to avoid unnecessary wear in transfer case?.I have a trick cable shifter for a 208 I’ll sell ya…. I bought it with the plan to mount it on a console but changed directions. It’s...
