CalSgt's latest activity
-
CSO LONG AS, you kept all your motor and trans mounts tight, Crossmember bolts tight, as well as your bell housing bolts, then you should...
-
CIt supports the transfer case. :Big Laugh: Sorry, I had to. :Big Laugh: I’ve never read a legit reason but I believe it’s to...
-
CCalSgt replied to the thread Transfer Case shifter ROD vs Cable? What are people using to avoid unnecessary wear in transfer case?.Me neither… A bazillion SB’s survived 300+ thousand miles without any issues caused by the shift linkage.
-
CCalSgt reacted to WebMonkey's post in the thread Transfer Case shifter ROD vs Cable? What are people using to avoid unnecessary wear in transfer case? with
Like.
sorry, i'm not. i can say that my 208 shifter+linkage doesn't seem to present pressure on it. slick and a bit of wiggle in the detents... -
CCalSgt reacted to Griffin's post in the thread New Badges for Military Service Members, LEO, FireFighters and EMT with Like.
We added new badges for military service members (active and retired) that are now broken down into your specific branch opposed to just...
-
CCalSgt replied to the thread Shifter help. Exhaust pipe in the way.Put a saw kerf in a 1 1/8" piece of plywood with my skill saw Built a support on the bottom that matched the profile of the Sawzall...
-
-
CBeen there before, my dad was over three packs a day, pretty sure that's the major contributor of what did him in.
-
CCalSgt replied to the thread Shifter help. Exhaust pipe in the way.Yeah but those pictures are old
-
CHave a picture with the shifter linkage that shows the clearance issue? It looks to me like it should fit and clear.
-
CCalSgt replied to the thread Shifter help. Exhaust pipe in the way.It doesn't look like you need too much to make it work, can you get the "z" bar in? Mine's not an LS but, I just bought a "U" bend and...
-
-
CCalSgt replied to the thread Emergency brake cable routing goes straight into exhaust.My older "K" truck has a little different style of e brake cable routing but I'm guessing you may need to weld some bends in your tubing...
-
